Dynex DX-CLTR01 Quick Setup Manual

Package contents

• Travel clock radio with digital FM radio
• AAA batteries (3)
• Quick Setup Guide

Features

Front view

DX-CLTR01
Travel Clock Radio
QUICK SETUP GUIDE

Back view

1 ALM 1
2 ALM 2
3 CLOCK SET
4 SNOOZE
5 PRESET/MEM
6 TUNE - / I<<
7 TUNE + / >>I
8 RADIO/ON/OFF/
9 SLEEP
10 VOL –
11 VOL +
12 Speaker
13 Stand
14 FM antenna*
15 Battery compartment cover
* The FM antenna is located in the battery compartment, which you need to
open to deploy the antenna.

Installing the batteries

1 Slide the battery compartment cover down and remove it.
2 Insert three AAA batteries (included) into the compartment. Make sure that
the + and – symbols on the batteries align with the + and – symbols in the
battery compartment.
3 Replace the cover.

Setting the time

1 Press and hold the CLOCK SET button for approximately three seconds. The
hour digit will flash on the display.
2 Press the TUNE+ or TUNE– button to set the current hour.
3 Press the CLOCK SET button to save the hour setting. The minute digit will
flash on the display.
4 Press the TUNE+ or TUNE– button to set the minutes.
5 Press the CLOCK SET button again to save the minute setting.

Using your clock radio

1 Press and hold the RADIO/ON/OFF/ button more than two seconds to turn
your clock radio on.
2 Press the RADIO/ON/OFF/ button more than two seconds again to put
your clock radio into standby mode.
3 Press the RADIO/ON/OFF/ button twice within 0.5 second to lock your
clock radio' s buttons.