Electrolux EIDW6305GS - 24-in Built in Dishwasher Specifications page 2

Dishwashers
EIDW6305GS
Built-In Dishwasher Specifications
Product Weight – 98 Lbs.
•
Voltage Rating – 120V / 60 Hz / 15 Amps
•
Connected Load (kW Rating) @ 120 Volts = 1.44 kW
•
(For use on adequately wired 120V, dedicated circuit having 2-wire
service with a separate ground wire. Appliance must be grounded
for safe operation.)
Amps @ 120V = 9 Amps
•
Always consult local and /or national electric & plumbing codes.
•
Water Pressure – Hot water line to dishwasher must provide between
•
15 and 120 pounds per square inch (psi).
Make sure location has right drain, water and electrical outlets to
•
make connections.
Keep back free of drain, water & electrical supply.
•
Electrical and water supplies should enter cabinet opening on floor,
•
or through back or side walls, as shown in shaded areas.
CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • electroluxappliances.ca
EIDW6305GS 12/10
Connections preferably located toward left side of dishwasher. Do not
•
cross drain, water or electrical lines in front of motor, blower or frame.
Minimum clearance of 1/4" required from unit to underside of countertop.
•
Leveling legs supplied to adjust height. (Note: Height only adjustable to
•
34-3/4" max. when installed in 35" max. standard cabinetry cutout to
allow for 1/4" min. clearance.)
When installing in corner, allow 2" clearance between opened door
•
and wall, to allow door to open.
When installing at end of cabinet line, sides must be fully enclosed.
•
Do not install unit under a cooktop, damage may occur.
•
Note: For planning purposes only. Refer to Product Installation Guide
on the web at electroluxappliances.ca or supplied with product
for detailed instructions.
© 2008 Electrolux Major Appliances, NA
High standards of quality at Electrolux Major Appliances mean we are
constantly working to improve our products. We reserve the right to change
specifications or discontinue models without notice.
Printed in Canada