Asko D3331 Quick Start Manual page 2

Q Q Q Q Q UICK ST UICK ST UICK ST
UICK ST UICK STAR
1. Load the dishwasher. (There's no need to pre-rinse. Simply scrape off large food particles before you
load the dishware.)
2. After you've pushed the baskets back inside the unit, manually rotate the upper and lower spray arms
to be sure they turn freely. Rearrange any item that blocks the wash arms.
3. Add 1 to 3 tablespoons of automatic dishwashing detergent and close the dispenser cover.
(See "Dishwashing Detergent" below.)
4. Make sure there is rinse aid in the dispenser. Add rinse aid, if needed.
5. Press the main power button on the top left side of the inner door panel to turn on power to the machine.
6. Close the door securely. (You should hear it click shut.)
7. Press the Program button until the desired program lights up.
8. Set the Temperature and Dry options as desired. Set Delay Start time, if desired.
9. Press the Start/Stop button. The dishwasher will start.
DISPLA DISPLA DISPLAY Y Y Y Y WINDO WINDO WINDOW W W W W WINDO
DISPLA DISPLA WINDO
After you press Start, the display window shows the time it took the program to run last time. (The first time you run a program, a 1 will display.)
As the program progresses, the time remaining displays. If the time exceeds an hour, the display alternates between the hour and minutes
remaining. The hour is designated by an h, e.g., 1h).
NOTE: The program times may not always be the same because of variations in the household hot water temperature. The dishwasher
heats the water to the proper temperature for the program selected; so if the temperature of the water entering the dishwasher is too low, the
dishwasher will run longer because it takes longer to heat the water. Raising your water heater setting could help to shorten the cycle times.
If you select Delayed Start, the window will display the number of hours selected. The window will then display the count down time until the
program starts.
The window also displays fault codes. See page 11 in your Use and Care Guide for a definition of these codes.
INTERRUPTING INTERR INTERR UPTING UPTING UPTING A PR
INTERR INTERR UPTING
If you want to interrupt a program to add an item, open the door slightly until the spray arms stop turning. You can then open the door fully and
place the item into the dishwasher. Close the door securely. The program will continue from where it was interrupted.
WARNING! Be extremely careful when opening the door during a program. The water is hot and you could get scalded.
CHANGING OR STOPPING A PROGRAM CHANGING OR STOPPING A PROGRAM CHANGING OR STOPPING A PROGRAM
CHANGING OR STOPPING A PROGRAM CHANGING OR STOPPING A PROGRAM
If you decide to change the program after you have started the machine, press the Start/Stop button for three seconds. You will have to select
the program and options again when you are ready to restart the program. (Note: If the program has already gone through the wash cycle,
you will have to add detergent.)
DISHWASHING DETERGENT DISHWASHING DETERGENT
DISHWASHING DETERGENT DISHWASHING DETERGENT DISHWASHING DETERGENT
We recommend that you use only unscented, granular automatic dishwashing detergent. Generally, one tablespoon of detergent is needed
for a normal wash load. More heavily soiled items, however, may need more detergent. Also, the amount of detergent needed can vary due
to differences in water hardness. The harder the water, the more detergent you may need. (See page 5.) In any case, you should never use
more than three tablespoons of detergent.
RINSE AID RINSE AID RINSE AID RINSE AID RINSE AID
Using liquid rinse aid prevents water spots from forming on dishes and improves drying by allowing water to "sheet" off the dishes. The rinse
aid is released during the final rinse. For information on how to fill the rinse aid dispenser and control the amount released, refer to your Use
and Care Guide.
NOTE: If you use a dishwashing detergent with a rinse aid additive, you should not fill the rinse aid dispenser.
CHILD-SAFE B CHILD-SAFE B
CHILD-SAFE B CHILD-SAFE BUTT CHILD-SAFE B
To prevent a child from accidentally starting the dishwasher or changing the program settings, the dishwasher can be programmed not to
start unless two buttons are held down simultaneously. Refer to your Use and Care Guide for instructions on how to activate this feature.
AR AR T PR T PR OCEDURES OCEDURES
AR ART PR T PR T PROCEDURES OCEDURES OCEDURES
A PR A PROGRAM A PR OGRAM OGRAM T T T T T O O O O O ADD OGRAM
A PR OGRAM
UTT UTT ON L ON L OCK OCK
UTT UTTON L ON L ON LOCK OCK OCK
Refer to your Use and Care Guide for additional information.
ADD ADD AN ITEM ADD AN ITEM AN ITEM AN ITEM
ADD AN ITEM
Refer to this page in
the Use & Care Guide.
3, 4
3
5
6
Art. 8077452. Rev 01