Network Menu - Dukane 8065 User Manual

Multifunctional settings

NETWORK Menu

Select [Network] from the main menu to access the following
functions.
NOTE • The factory default setting for DHCP is "TURN ON". There is no need to set
up [DHCP], [IP ADDRESS], [SUBNET MASK] or [DEFAULT GATEWAY] if your network
has DHCP enabled. ( User's Manual - Network Functions)
• If you are not utilizing SNTP ( User's Manual - Network Functions), then you must
set the DATE AND TIME during the initial installation. Please refer to the item DATE AND
TIME on the following list.
NOTE Consult with your network administrator before connecting to an existing
access point on your network. Incorrect network settings on this projector may cause
trouble on the network.
Item
DHCP TURN ON/TURN OFF:
DHCP
Use the ▲/▼ buttons to turn DHCP on/off
(Dynamic Host
Configuration
Select TURN OFF when the network does not have DHCP
Protocol)
enabled.
Entering the IP ADDRESS :
Use the ▲/▼/◄/► buttons to enter the IP
ADDRESS. This function can only be used
when DHCP is set to "TURN OFF".
IP ADDRESS
~Note~
The IP ADDRESS is the number that identifies this projector on the
network. You cannot have two devices with the same IP ADDRESS
on the same network.
Entering the SUBNET MASK :
Use the buttons ▲/▼/◄/► to enter the
SUBNET MASK same SUBNET MASK used by your PC.
This function can only be used when DHCP
is set to "TURN OFF".
56
8755D-RJ only! (LAN)
TURN ON  TURN OFF
MENU [RGB]
PICTURE
IMAGE
INPUT
SETUP
SCREEN
OPTION
NETWORK
EASY MENU
Operation
192. 168.
255. 255.
:SELECT
TURN OFF
DHCP
IP ADDRESS
SUBNET MASK
DEFAULT GATEWAY
DATE AND TIME
TIME DIFFERENCE
e‑SHOT
INFORMATION
DHCP
TURN ON
TURN OFF
1. 254
IP ADDRESS
255. 0
SUBNET MASK