Table of Contents
Advertisement
Front Panel LEDs
2-7
PWR (Power) When lit indicates that the module is receiving power from
the chassis' backplane and that the power circuits are functioning correctly.
ALARM Lights to indicate that an event has occurred on one or more
of the modems which has been configured to raise an alarm. See the
AccessBuilder 7000 Access Concentrator User Guide for more information.
ALERT Lights to indicate that an event has occurred on one or more of
the modems which has been configured to raise an alert. See the
AccessBuilder 7000 Access Concentrator User Guide for more information.
TEST Indicates that one of the modems on the module is running a
test. This may have been initiated either by an attached DTE, via the
Management Controller Module or by a remote DTE to which the
modem has a communications link.
SEND Flashes on and off to indicate that the selected modem is
receiving data from the equipment attached to the DTE interface.
REC (Receive) Flashes on and off to indicate that the selected modem
is passing received data from the line to the DTE interface.
CH 1 (Modem 1) Shows that Modem 1 is selected and that the LEDs show
the status of this modem.
CH 2 (Modem 2 Shows that Modem 2 is selected and that the LEDs show
the status of this modem.
CH 3 (Modem 3) Shows that Modem 3 is selected and that the LEDs show
the status of this modem.
Push Button Selects the modem whose status is shown by the front
panel LEDs. Toggle this button until the required Modem LED is lit.
Advertisement
Table of Contents
