Table of Contents
Advertisement
.
IDE connectors (40-1 pin PRI_IDE, SEC_IDE)
The onboard IDE connectors are for Ultra DMA 133/100/66 signal
cables. There are three connectors on each Ultra DMA 133/100/66
signal cable: blue, black, and gray. Connect the blue connector to
the motherboard's IDE connector, then select one of the following
modes to configure your device(s).
Single device
Two devices
•
Pin 0 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
•
Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE
devices.
If any device jumper is set as "Cable-Select," make sure all other device
jumpers have the same setting.
A8V-VM ULTRA
A8V-VM ULTRA IDE Connectors
ASUS A8V-VM Ultra
Drive jumper
setting
Cable-Select or Master
Cable-Select
Master
Slave
Mode
Cable
of device(s)
connector
-
Black
Master
Black
Slave
Gray
Master
Black or gray
Slave
1-3
Advertisement
Table of Contents
