NETGEAR WNDR3300v1 - RangeMax Dual Band Wireless-N Router Setup Manual page 11

Push the wireless router's dome for 5 seconds, then release. The dome lights should begin
b.
to blink.
While the router is in WPS enable mode (a maximum of 2 minutes), wireless
security is not enabled. Indoors, computers can connect over wireless networks
at a range of several hundred feet. Unlike wired network data, your wireless
data transmissions can extend beyond your walls, and anyone with a
compatible adapter can receive them, allowing others outside your immediate
area to access your network. For more information about security, see the
Reference Manual that is available from a link on the Resource CD as well as a
link in the main menu of your router.
While the dome lights are blinking, you have 2 minutes to enable WPS on the device you
c.
are trying to connect with the router. The blinking ceases when one of these two
conditions occurs:
– WPS is enabled between the router and the other device you are connecting to.
– The 2-minute window period expires for establishing a WPS connection. Whether or
not a connection is established, your router security and SSID (service set
identification key) are now configured for WPS.
The lights return to off or antenna display, depending on how you have set them.
d. If after enabling WPS you need to connect a device that does not include WPS
functionality, you will need to first log in to the router and obtain the security key. For
more information, refer to
for New Firmware" on page
the Resource CD.
e. If you want to disable WPS, you have to reset your router to factory default settings. For
information about resetting to the default settings, see
and Configuration Settings" on page
Getting to Know Your Wireless Router
"Accessing the Wireless Router after Installation and Checking
16, and the online Reference Manual, available as a link on
32.
v1.0, November 2007
Wireless Router Setup Manual
"Restoring the Default Password
7