AllerAir Air Rhino AR 2000 Replacement Manual

Warning: Before
The Pre-filter
Should be changed daily in an industrial application and as needed in a light applicati
Unsnap the door latches and open the door.
Remove the used pre-filter and replace with a new pre-filter
Close the door and relatch the snaps
See diagram on reverse
The Dust Filter
Should be changed every 2 to 3 days in an industrial application and as needed in a ligh
application
Unsnap the door latches and open the door.
Remove the used Dust filter and replace with a new pre-filter
Close the door and relatch the snaps
See diagram on reverse
The HEPA Filter
Note: May be equiped with AWCF0314 carbon filter.
Should be changed when the gauge reads: and above 1.7 or when the light comes on depending
on how unit is equiped.
Unsnap the door latches and open the door.
Remove the prefilter, wire-frame filter and carbon filter if supplied.
Loosen wing nuts and remove the HEPA filter
Reverse the above procedure to replace the HEPA filter
Dispose of used filters according to local environmental regulations
See diagram on reverse
The Carbon Filter
Should be changed as required - Life of the carbon depends on what and how much product
it is adsorbing. The only way to know carbon has reached its capacity is when it starts to off gas.
Record the first time it starts to off gas and schedule to change the carbon one or two months
before. You have created your schedule.
Unsnap the door latches and open the door.
Remove the pre-filter and the wire-frame filter
Loosen wing nuts and remove the HEPA filter
Reverse the above procedure to replace the HEPA filter
Dispose of used filters according to local environmental regulations
For maximum performance it is very important to change filters as
Trouble Shooting Guide
Symptoms
Unit will not start
Insufficient air flow
Excessive airflow
AR 2000 and AR 4000
Dual Purpose Air Rhino Units
and
Filter Replacement Directions
opening unit for any reason unplug the unit
(part #AWFP2424)
-
(part #AWFD2424)
(part #AWHF0411)
-
(part #AWCF0500)
specified in these directions
Possible Cause
Faulty power supply
Return or supply grill blocked
Blown fuse
Unit not plugged in
Obstruction in system
Clogged filters
Filters not in place
Filter Change Directions
–
Canister Only
Suggested Solution
Check breaker box
Remove obstruction
Replace fuse
Plug in unit
Remove obstruction
Replace filters
Install filt ers