Table of Contents
Advertisement
ADDING ELBOW FOR EXHAUST
THROUGH BOTTOM OF CABINET
• Insert the elbow through the rear opening and connect it to
the dryer internal duct.
• Apply duct tape on the joint between the dryer internal
duct and elbow, as shown on page 7.
CAUTION:
Internal duct joints must be secured with tape,
otherwise they may separate and cause a
safety hazard.
ADDING COVER PLATE TO REAR
OF CABINET
PLATE
(KIT WE1M454)
Connect standard metal elbows and ducts to complete the
exhaust system. Cover back opening with a plate (Kit
WE1M454) available from your local service provider.
Place dryer in final location.
WARNING - NEVER LEAVE THE
BACK OPENING WITHOUT THE PLATE.
TO REGISTER YOUR DRYER
CALL TOLL-FREE
1-888-269-1192
Prompt registration confirms your right to protection under the
terms of your warranty.
www.GEAppliances.com
For Questions on Installation, Call: 1-800-626-2003 (US) or
1-800-361-3400 (Canada).
500A187P038
Installation Instructions
8
Pub. #31-15476
13 CHANGING DIRECTION OF
DOOR OPENING
REMOVE 4
HINGE SCREWS.
0
ROTATE DOOR 180
AND REINSTALL.
14 SERVICING
WARNING - LABEL ALL WIRES
PRIOR TO DISCONNECTION WHEN
SERVICING CONTROLS. WIRING
ERRORS CAN CAUSE IMPROPER AND
DANGEROUS OPERATION AFTER
SERVICING/INSTALLATION.
For replacement parts and other information, refer to
Owner's Manual for servicing phone numbers.
REMOVE 4 HOLE PLUGS AND
PLACE THEM IN THE HOLES
ON THE OPPOSITE SIDE.
Advertisement
Table of Contents
