Kenmore 7965 - 600 5.9 cu. Ft. Capacity Gas Flatback Dryer Installation Manual page 3

WASHER INSTALLATION
(See page 4 for dryer instructions.)
O Level the washer on the pedestal by adjusting the
feet.
O Move the washer to the desired place.
NOTE: The appliance and pedestal assembly must be
placed on a solid and level floor for proper operation.
Adjust the legs of the appliance and pedestal by turning
with a wrench. Then, tighten the lock nut against the
base of the pedestal with the wrench while holding the
leg to make sure it does not turn.
Lock nut_
Adjustable feet
Lock nut
O Check the alignment of the washer with the pedestal.
Make sure the washer base brackets align with the
brackets on the pedestal, then install 4 screws at
each corner to securely attach the appliance to the
pedestal.
NOTE: If the screws are not installed properly, noise
and vibration may result.
Adjustable feet
NOTE: Diagonal Check
Once the pedestal feet are adjusted,
rock the washer very firmly in a
diagonal direction, If one direction
moves more than the other, readjust
the front feet until both directions are
even.
NOTE: To make sure that the washer
is properly level, run the washer with a
test load: place approximately 6 pounds of laundry in
the machine. Then press POWER, press RINSE &
SPIN, and then press the START/PAUSE button (If the
washer does not have the RINSE & SPIN, press
EXPRESS WASH instead of pressing RINSE & SPIN.).
Verify that the washer does not rock or vibrate
excessively during the spin cycle. If the washer vibrates
or shakes, adjust the leveling feet while the washer is
spinning to minimize the vibration.
3