Function Test Sequence - Frigidaire FAQE7001LB Wiring Diagram

FUNCTION TEST SEQUENCE

1. Turn knob to sixth position from the left.
2. Press and hold SELECT and CANCEL simultaneously for six seconds. The buzzer will sound one time.
3. Immediately press and hold OPTIONS and CANCEL simultaneously for two seconds. The control will enter test mode,
the buzzer will sound three times and all LEDs will rapidly flash.
After entering the test mode, the cycle selector knob can now be rotated to select the following tests:
Rotate the cycle selector knob clockwise from the starting position:
0 turns: All LEDs will flash.
1 turn: Drive motor runs; heat source is on. Drying LED is lit. "H" and the control thermistor reading will toggle
back and forth in the display.
2 turns: Drive motor runs; heat source is off. Cool Down LED is lit and "AF" (Air Fluff) is displayed.
3 turns: Drive motor runs; heat source is off. Drying and Cool Down LEDs are lit and numbers appear in the
display showing moisture sensor readings. Opening the door (press in on door switch plunger) and placing
a finger on the both moisture sense bars at the same time will make the numbers decrease. In controls that
do not have a digit display, the More Dry LED should be ON. Opening the door (press in on door switch
plunger) and placing a finger on the both moisture sense bars at the same time will make the Damp LED
come on.
4 turns: Drive motor runs; heat source is off.
Key test:
a. When the Temperature key is pressed, all the temperature LEDs should light.
b. When the Dryness key is pressed, all the dryness level LEDs should light.
c. When the Options or Select key is pressed, all the Option LEDs should light.
d. When the Start/Pause key is pressed, all the cycle status LEDs should light.
e. When the Cancel key is pressed, all the cycle status LED's should light.
5 turns: Drive motor runs; heat source is off. Cool Down LED is lit. Control thermistor reading is displayed.
6 turns: Drive motor runs; heat source is on. Drying LED is lit. Control thermistor reading is displayed.
7-11 turns: All LEDs will flash
To EXIT test mode, press and hold the Select and Cancel buttons simultaneously for 6 seconds or disconnect power
from dryer. Dryer will be reset for regular operation.