Summary of Contents for Dreamer Design Verve SPT SPT
Page 1
Before we walk you through the simple assembly of your new stroller we would like you to take a moment and read through the entire instruction booklet to insure the process goes as smoothly as possible.
Page 2
Check to make sure you have all the parts and necessary items needed to assemble the stroller. If you don't have something that is pictured please call our customer service line at 800.278.9626.
Page 3
Tip the stroller back so it is resting on its handle and rear wheels to put the front wheel on. Remove the fork tip protectors.
Page 4
a s s e m b l y Starting at the bottom of the brake pads, push the wheel up and in between the brake pads. Rotate the tire upwards and find the flat sides on the round axle and slide all the way to the back of the forks, on BOTH The quick release lever should be straight out.
Page 5
NEVER trust your brakes 100%! Always keep an eye on your stroller. Always use your safety wrist strap any time a child is in the stroller. check to make sure the brake caliper is locked before each use...
Page 6
Your canopy has multiple adjustments to fill all of your's and your child's needs. Use the canopy at it's fully extended position during midday sun to provide your child with the most amount of shade. To bring the canopy to it's next position, flip the mesh portion under.
Page 7
Before washing the canopy, remove the frame. The canopy may be washed in cold water with mild detergent. Place the canopy back on the stroller to dry. When the canopy is wet, extend it fully until completely dry to prevent any mildew from forming.
Page 9
Another place for storage is the basket under the seat. WARNING Do not store more than 12 pounds between the pockets and basket. Overloading the stroller may cause it to become unstable and tip over.
Page 10
Tighten the tire again and push to stroller to see if it rolls straight. If it pulls to the left, shift the tire to the right.
Page 11
m a i n t e n a n c e We recommend that you have an experienced dealer perform these maintenance checks once a year. Lubrication of the following items is necessary: 1 pivot point and cable of hand brake 2 hand brake cable by caliper lever 3 front wheel axle 4 quick release lever...
Need help?
Do you have a question about the Verve SPT SPT and is the answer not in the manual?
Questions and answers