Headlamp High/Low-Beam Changer - Cadillac ESCALADE EXT 2002 Manual

Turn Signal and Lane-Change Signals
The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow
you to signal a turn or a lane change.
To signal a turn, move the lever all the way up or
down. When the turn is finished, the lever will return
automatically.
To signal a lane change, just raise or lower the lever
until the arrow starts to flash. Hold it there until you
complete your lane change. The lever will return by
itself when you release it.
If you move the lever all the way up or down, and the
arrow flashes at twice the normal rate, a signal bulb
may be burned out and other drivers may not see your
turn signal.
An arrow on the instrument
panel cluster will flash in
the direction of the turn or
lane change.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows don't go on at all when you
signal a turn, check for burned
(see "Fuses and Circuit Breakers" in the Index).
Turn Signal On Chime
If your turn signal is left on for more than 3/4 of a mile
(1.2 km), a chime will sound at each flash of the turn
signal. To turn off the chime, move the turn signal lever
to off.

Headlamp High/Low-Beam Changer

To change the headlamps from low to high beam or high
to low beam, pull the multifunction lever all the way
toward you. Then release it.
-
out bulbs or a blown fuse
When the high beams
are on, this light on the
instrument panel cluster
also will be on.
2-43