Advertisement
Tape Measure, Level, Drill, ¼" Bit, 9/16 Socket, 1 ¼" Forstner Bit
1.
The rough opening height must be 83" and the rough opening width must be 36".
2.
Using a tape measure, check the rough opening. Measure diagonally across the
opening. Diagonal measurements need be equal within ¼".
Security Door Installation Instructions
Tools Needed:
Advertisement
Table of Contents
Summary of Contents for Browning SECURITY DOOR
- Page 1 Security Door Installation Instructions Tools Needed: Tape Measure, Level, Drill, ¼” Bit, 9/16 Socket, 1 ¼” Forstner Bit The rough opening height must be 83” and the rough opening width must be 36”. Using a tape measure, check the rough opening. Measure diagonally across the opening.
- Page 2 Referencing drawing above, drill a 3/8” thru hole in the proper location (3.75 from outer edge of sheet rock) Referencing drawing above step three, create a 1.25” diameter cavity 3/8” deep ” in the stud. Center of cavity should be centered at center of 3/8” thru hole. Move security door and frame into location near rough opening.
Need help?
Do you have a question about the SECURITY DOOR and is the answer not in the manual?
Questions and answers