Belt Clips; Turning The Handset On/Off - Doro PMR 510 User Manual

English
Setting Up

Belt clips

A belt clip is included, which can be fitted on the back of the handset once the
batteries have been installed. The belt clip allows the handset to be attached to
a belt, waistband or similar.
To remove, lift the small tab at the top of the clip and simultaneously push
upwards.
Range
The communication range is dependent on many factors, with the maximum
range being achieved when there are no obstacles in the transmission path (line
of sight). Under optimum conditions the maximum range can be up to 5km.
There will be a reduction in the range when the units are used in built up areas,
undulating terrains and vehicles.
Headset
The handset can be used with the headset supplied in the optional Accessory
Pack (pmr a-pack) which can be purchased from your local DORO retailer.
When the headset is connected, the microphone and speaker on the handset are
automatically disconnected, all other functions remain unchanged.
Please note!
Use only DORO original headsets with these PMR units.
Adjust the Call signal and headset volume immediately upon connecting a headset, as these
settings may initially be too loud.

Turning the handset On/Off

To turn the handset On or Off press and hold the button (1-2 seconds) until
!
a tune is heard.
4 www.doro.com