Advertisement
EPL-7000 cont.
[S] WARMING UP
The printer is warming up.
Note:
lf any of the following messages appear, turn the printer off for at least five
seconds, then turn it back on. lf the same message is displayed, repair is
required.
SCAN MOTOR ERROR
HSYNC ERROR
HEATER LAMP ERROR
MAIN MOTOR ERROR
FAN MOTOR ERROR
ES300C Display Codes
E-C
Command error. An unidentified command or parameter was detected.
E-l Interface error
a. Incorrect communication parameter received.
b. Broken connector or wire.
c. Host failed to respond within 30 seconds.
d. Host is not accepting data. (DSR= Low)
E-F Fatal error
a. A lamp is broken.
b. Power is applied before the transportation screws were removed.
c. System failure
GQ-3500 Display Codes
do
Cover Open error
Engine driver CPU error.
Option tray CPU error.
Option tray motor error.
PSB No: P-0077
Page: 9 of 11
Advertisement
