DOD SR835 Owner's Manual
  1. Manuals
  2. Brands
  3. DOD Manuals
  4. Crossover
  5. SR835
  6. Owner's manual

DOD SR835 Owner's Manual

Dod stereo equalizers owner's manual sr835
Hide thumbs

Advertisement

Table of Contents

SR835 Crossover
A Harman International Company

Advertisement

Table of Contents
loading

Related Manuals for DOD SR835

Summary of Contents for DOD SR835

  • Page 1 SR835 Crossover A Harman International Company...

  • Page 2: Safety Instructions

    These symbols are internationally accepted symbols that warn of potential hazards with electrical products.The lightning flash means that there are dangerous voltages present within the unit.The exclamation point indicates that it is necessary for the user to refer to the owners manual. These symbols warn that there are no user serviceable parts inside the unit.
  • Page 3 This Owner’s Manual is your guide to understanding how to get the most out of the SR835. Please read it carefully and familiarize yourself with the controls on the SR835. By doing so, you will be assured to increase the over all efficiency of your system for years to come.

  • Page 4: Front Panel

    SR835 Crossover FRONT PANEL 1. Power Switch - Used to engage or disengage the power to the SR835. 2. Mono/Stereo Switch - This switch configures the SR835 as two indepen- dent channels of 2 way splits, or one channel with a 3 way split.When the switch is in and the LED is lit, the SR835 is in Mono mode.

  • Page 5: Rear Panel

    12. Power Receptacle - Connect the provided power cord from this recepta- cle to an AC outlet. SR835 Crossover WARNING: SHOCK HAZARD-DO NOT OPEN AVIS: RISQUE DE CHOC ÉLECTRIQUE-NE PAS OUVRIR LOW SUM OUT HIGH BAL.

  • Page 6: Installation

    Since the units draw a relatively small amount of current during idle, they can be left on continuously. DOD crossovers generate very little heat during operation and thus do not need to be specially ventilated or cooled. The units should not, however, be sub- jected to high temperatures for extended periods.
  • Page 7 Begin these steps with the power to the SR835 turned off. 1. Make sure the Mono Mode switch on the front panel of the SR835 is in the “out” position. The LED next to this switch should be off.
  • Page 8 Begin with the power turned off. 1. Make sure the Mono Mode switch on the front panel of the SR835 is in the “in” position. The LED next to this switch should be on.

  • Page 9: Maintenance And Servicing

    All service and repair must be performed by the factory or an authorized service center for the warranty to remain in service. Should a problem arise with the equalizer, please contact your authorized DOD Electronics dealer for return/repair procedures.
  • Page 10 1. The warranty registration card must be mailed within ten days after pur- chase date to validate this warranty. 2. DOD warrants this product, when used solely within the U.S., to be free from defects in material and workmanship under normal use and service.
  • Page 11 DOD Electronics Corporation President of DOD 8760 S. Sandy Parkway Sandy, Utah 84070, USA Effective: 11/24/97 European Contact: Your Local DOD Sales and Service Office or International Sales Office 8760 S. Sandy Parkway Sandy, Utah 84070, USA Tel (801) 568-7638...
  • Page 12 DOD E ISIT LECTRONICS ON THE DOD E 8760 S NTERNATIONAL 8760 S IS A EGISTERED © 1998 DOD E ORLD HTTP LECTRONICS ORPORATION OUTH ANDY ARKWAY 84070 ANDY 801-566-8800 ELEPHONE 801-566-7005 ISTRIBUTION OUTH ANDY ARKWAY 84070 ANDY 801-568-7638 ELEPHONE...

Table of Contents