Sony PCWA-A100 - Wireless Lan Access Point Getting Started page 17

Setting up cable connection
Selecting Cable Modem for Connection Mode in
Hints
 The Access Point acts as a NAT router w hen Cable Modem is selected for Connection Mode.
 Select this mode w hen connecting the Access Point to a DSL modem if your DSL provider does not use PPPoE for connection.
1. Click the IP Se tup tab.
This dialog box is for entering the information required for configuring a WAN (Wide Area Netw ork) and assigning local IP addresses.
Static IP Address (WAN-side)
Check this option if the IP address to be used on the computer is specified in your cable modem contract, then fill in the follow ing fields.
If this option is left unchecked, the IP address is automatically assigned w hen connection to the ISP is established.
Hint
Ask your ISP (cable TV company) for more information.
WAN IP Address
Enter the IP address of the WAN.
WAN Subnet Mask
Enter the subnet mask of the WAN.
Default Router
Enter the IP address of the default router.
DNS Server 1
Enter the primary DNS server address.
DNS Server 2
Enter the secondary DNS server address.
Local IP Address
Enter the IP address of the LAN.
Hint
The Local IP Address is assigned by default. There is no particular need to change them.
Local Subnet Mask
Enter the subnet mask of the LAN.
Hint
The Subnet Mask is assigned by default. There is no particular need to change them.
Setting mode-dependent parameters displays the Setup of Cable Modem Connection Mode dialog box.
Page 17