Dixon ZTR 560 Operator's Manual page 10

SEAT ASSEMBLY INSTRUCTIONS
Place seat back against frame of seat bottom. Align top & bottom holes in frame with the t-nuts in
1.
seat back. Insert (4) 1/4-20 Phillips machine screws to attach frame to seat back. DO NOT
TIGHTEN SECURELY.
2. Place (1) armrest bracket against seat back, aligning mounting holes in bracket and seat back.
Insert (2) 5/16-18 X 5/8" tapping screws through holes in bracket & frame and start screw threads.
3.
DO NOT TIGHTEN SECURELY.
Insert (1) 1/4-20 X 3/4" Phillips machine screw through remaining hole in bracket and start screw
4.
threads. DO NOT TIGHTEN SECURELY.
5. Repeat steps 2 through 4 for the other armrest.
6. Tighten all screws.
Align back cover to seat back. Secure with (4) #14 X 5/8" wood screws and (4) 5/16" SAE washers
7.
in recesses provided.
Slide armrest onto mounting bracket pin.
8.
9. Insert set screw in rear of armrest, securing armrest to mounting bracket.
Repeat steps 8 & 9 for other armrest.
10.
11. Center utility box on seat back cover and fasten with drill & tap screws and washers provided in
separate hardware package.
Page 7