Table of Contents
Advertisement
UPPER CONTROL LEVER INSTALLATION
1
Raise rear body cover to fully open position.
2.
Install flat washer on right hand swivel plate weldment. Next install right hand
control lever, then second flat washer.
3.
Push control lever into the neutral slot and install (2) cup washers, (1) flat washer
and jam nut. (See illustration)
4.
Tighten jam nut. Proper tightness or tension on jam nut is achieved when swing out
movement of upper control levers requires some pressure. Levers should not fall to
the side or be sloppy in movement.
5.
Repeat above procedure on left side.
Page 8
Hide quick links:
Advertisement
Table of Contents
