Gain; Bypass; Range - PRESONUS DEQ624 User Manual

CONTROLS & CONNECTIO NS
T H R E S H O L D
The Threshold control for the Limiter is calibrated from dBu to Off.
A Gain control on each channel of the DEQ 624 is the last controller in the signal
path and is used to compensate for signal level loss from dynamics processing.
The control is centered at and with a Cut / Boost capability from
dBu.
A Bypass switch on each channel redirects signal to a hard-wire bypass
connection that takes the DEQ 624 circuitry out of the signal path. This switch
lights up when Bypass is ON. The DEQ 624 metering system continues to
monitor processor activity in Bypass mode.
Each channel has a Range switch for selecting the range of control for the graphic
equalizer section' s digital EQ encoders. One of three LED' s per channel located
at the extreme left side of the face of the unit light up when selected to indicate
the current range for the graphic equalizer' s digital encoders. A lighted Red LED
indicates a range of or
of or dB and a Lighted Green LED indicates a selected range of
dB. The selected range for a channel is applied to all digital EQ encoders in
Manual mode or when setting up a program to be stored in a Preset position. If a
set-up procedure is begun and a change in the range of control of the encoders is

Gain

Bypass

Range

dB; a lighted Amber LED indicates an available range
12
dBu to
or