Directed Electronics Xtreme XA-3002 Owner's Manual
  1. Manuals
  2. Brands
  3. Directed Electronics Manuals
  4. Car Amplifier
  5. Xtreme XA-3002
  6. Owner's manual
Directed Electronics Xtreme XA-3002 Owner's Manual

Directed Electronics Xtreme XA-3002 Owner's Manual

Directed electronics amplifier owner's manual
Hide thumbs

Advertisement

Table of Contents

XA-3002
XA-6002
XA-6004
XA-5001
XA-8001

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Xtreme XA-3002 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Directed Electronics Xtreme XA-3002

Summary of Contents for Directed Electronics Xtreme XA-3002

  • Page 1 XA-3002 XA-6002 XA-6004 XA-5001 XA-8001...

  • Page 2: Table Of Contents

    Front Panel Connections/Controls ......6 REAR Panel Connections—XA-3002/XA-6002 ....11 High Level Harnesses .

  • Page 3: Limited Two-Year Consumer Warranty

    WARRANTY, IMPLIED WARRANTY, WARRANTY MERCHANTABILITY, FITNESS FOR PARTICULAR PURPOSE, AND © 2006 Directed Electronics—all rights reserved WARRANTY OF NON-INFRINGEMENT OF INTELLECTUAL PROPERTY ARE EXPRESSLY EXCLUDED TO THE MAXIMUM EXTENT ALLOWED BY LAW, AND DIRECTED NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO ASSUME FOR IT ANY LIABILITY IN CONNECTION WITH THE SALE OF THE PRODUCT.

  • Page 4: Features

    5. Avoid sharp metal areas when routing cables to the amplifier, and run RCA cables away from the power cables and other potentially noisy car harnesses. © 2006 Directed Electronics—all rights reserved...
  • Page 5 Remember, the amplifier can only deliver its rated output when it is © 2006 Directed Electronics—all rights reserved not current limited by the power and ground supply wires. 8. This amplifier is designed to drive a speaker load that measures from 2 to 4 ohms.

  • Page 6: Front Panel Connections/Controls

    (reverse power). If the temperature, DC offset, or short condition has cleared after approxi- mately 10-seconds the amplifier will automatically recover. © 2006 Directed Electronics—all rights reserved...
  • Page 7 L L o o w w - - P P a a s s s s F F r r e e q q u u e e n n c c y y C C o o n n t t r r o o l l (front) - adjusts frequency (50Hz–500Hz) of the low-pass crossover. © 2006 Directed Electronics—all rights reserved BASS LOW PASS HI PASS X-OVER...
  • Page 8 11. C C r r o o s s s s o o v v e e r r S S w w i i t t c c h h (rear) - activates low pass crossover, full (all pass), or high pass crossover. © 2006 Directed Electronics—all rights reserved...
  • Page 9 1V. 3. R R C C A A O O u u t t p p u u t t - RCA output to another amplifier. © 2006 Directed Electronics—all rights reserved REAR HI-INPUT INPUT...
  • Page 10 (reverse power). If the temperature, DC offset, or short condition has cleared after approxi- mately 10-seconds the amplifier will automatically recover. INPUT LEVEL X-OVER LOW PASS BASS FULL 12dB 0.15V 30Hz 250Hz © 2006 Directed Electronics—all rights reserved...

  • Page 11: Rear Panel Connections-Xa-3002/Xa-6002

    See specification for fuse size for your amplifier. N N o o t t e e : : The XA-3002 has only one fuse. 12. ( ( + + ) ) 1 1 2 2 V V o o l l t t P P o o w w e e r r - Connect this...
  • Page 12 SPEAKER WIRING DIAGRAM—XA-3002/XA-6002 2-CHANNEL XA-3002/XA-6002 SPEAKER 4 Ohm BRIDGED (R-) (R+) (L-) For bridging into a single speaker load, the XA-3002/6002 have the ability to be bridged, as shown in the diagram below: 2-CHANNEL XA-3002/XA-6002 BRIDGED BRIDGED (R-) (R+) (L-) SPEAKER 4 Ohm Note: Model XA-3002 has one fuse.
  • Page 13 RIGHT SPEAKER 4 Ohm REAR For bridging front and rear into single speaker loads, the XA-6004 has the ability to be bridged as shown in the diagram below: © 2006 Directed Electronics—all rights reserved LEFT SPEAKER 4 Ohm (L-) (L+)
  • Page 14 4-CHANNEL XA-6004 BRIDGED FRONT (R-) (R+) FRONT REAR (R-) (R+) SPEAKER 4 Ohm REAR SPEAKER 4 Ohm BRIDGED (L-) (L+) FUSE FUSE (L-) (L+) © 2006 Directed Electronics—all rights reserved +12V...
  • Page 15 N N O O T T E E ! ! The XA-5001 and XA-8001 are not designed to work in a bridged or strapped configuration. Attempting to apply these configurations will damage the amplifier and will not be covered under warranty. © 2006 Directed Electronics—all rights reserved SPEAKER 4 Ohm...

  • Page 16: High Level Harnesses

    Input Connection + Left Front channel - Left Front channel Ground - Right Rear channel + Right Rear channel + Right Front channel - Right Front channel - Left Rear channel + Left Rear channel © 2006 Directed Electronics—all rights reserved...

  • Page 17: Crossover Settings And Gain Adjustment

    Again, plan on spending some time with music that you know, getting the gain and crossover settings the way you like. Test discs and analyzers may help with this process, but in the end it's your ears that count - listen to the music! © 2006 Directed Electronics—all rights reserved...

  • Page 18: Cea Specifications

    Power Output: 300 Watts RMS x 1 at 4 ohms and < 1% THD+N Signal to Noise Ratio: -75 dBA (reference 1 Watt into 4 ohms) Additional Power Output: 400 Watts RMS x 1 at 2 ohms and < 1% THD+N © 2006 Directed Electronics—all rights reserved...

  • Page 19: Specifications

    SPECIFICATIONS Xtreme models XA-3002 XA-6002 XA-6004 XA-5001 XA-8001 Type 2-channel Maximum Power 300 watts Damping Factor >150 Frequency Response 20Hz-20kHz +0, -3dB Crossover (12dB Slope) LP 50-500Hz Bass Boost (@ 50Hz) Switch 0, +6, +12dB Input Sensitivity 150mV-5V Protection Thermal, Overcurrent, Short Circuit, Reverse Polarity...
  • Page 20 © 2006 Directed Electronics - All rights reserved - G43100/05/10/15/20 04-06...

This manual is also suitable for:

Xtreme xa-8001Xtreme xa-6002Xtreme xa-5001Xtreme xa-6004

Table of Contents

Save PDF