Visioneer VISIONAID 96-0200-000 Maintenance Instructions

Maintenance Kit for an Auto Document Feeder (ADF) with Flatbed Scanner

This Kit Contains

Maintenance
Instructions
1
The contents of this kit should be kept in a clean, dry area and out of the reach of children.
2
Do not attempt to clean the black paper-sensor arm, wipe gently around this area without touching the paper
sensor.
3
This number varies based on scanner model, paper weight, paper texture, size of scan batches and frequency
of scanning.
♦ 1 Bottle of Streak-Free De-Ionized Cleaning Solution
♦ 10 Lint-Free Dry Cleaning Cloths (White)
♦ 5 Dry Cleaning Cloths (Blue)
♦ 3 Scan Through Staticide Wipes
♦ 10 Isopropyl Alcohol Pre-Moistened Cleaning Wipes
♦ 2 ADF Pad Assemblies

♦ Cleaning Instructions

♦ Dry Cleaning Cloth & Cleaning Solution (Flatbed Only)
• Spray the flatbed glass with the De-Ionized Cleaning Solution
• Wipe the glass clean using a lint-free dry cloth (white)
• Clean the ADF scan frame (small strip of glass with a white
frame and is the only area where ADF images are captured)
• Spray the cleaning solution onto a dry cleaning cloth (blue) to
clean the outside of the scanner and the cables

♦ Scan-Through Staticide Wipes (ADF Only)

• Pre-moistened 8.5x11 pads; keep sealed until use
• Open the package and take out the pre-moistened pad
• Unfold the pad and place in the ADF
• Scan the pad as you would a regular piece of paper
• Take the pad from the output bed and repeat the scan
process 4 additional times then delete resulting scan images

♦ Pre-Moistened Cleaning Wipes

• Use these wipes between Staticide Scan Through cleanings
• Open the ADF door and wipe down all plastic surfaces
• Wipe and rotate the rollers to ensure the entire surface of
each roller is clean, wipe down the ADF pad
• DO NOT vigorously rub these across the rollers

♦ ADF Pad Assemblies

• ADF Pads push the paper against the main pick-up roller and
is a user replaceable, consumable part
• Each pad can be used for up to 20,000
• Open the scanner and remove the ADF Pad by pinching the
plastic clips on either side of the metal bar, place a new pad
in the scanner, press on the metal bar until it snaps into place
Note: The scanner should be powered off for all cleaning methods except for when
using the Staticide Pads.
2
3
scans
1