Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Directed Audio Model 2500
Summary of Contents for Directed Audio Model 2500
- Page 1 model 2500...
-
Page 2: Table Of Contents
The Directed Audio 2500 five-band is covered by two-year limited warranty. Be sure to retain your original sales receipt, and refer to the warranty section of this guide for full details about your coverage. -
Page 3: Limited Two-Year Consumer Warranty
LIMITED TWO-YEAR CONSUMER WARRANTY Directed Electronics, Inc. promises to the original purchaser, to replace this product should it prove to be defective in workmanship or material under normal use, for a period of two years from the date of purchase by the dealer as indicated by the date code marking of the product PROVIDED the product was installed by an authorized Directed dealer. -
Page 4: Features
FEATURES Five-band graphic equalizer with 18dB boost/cut. Dual-function volume/fader control knob. Dedicated subwoofer output with adjustable low-pass crossover. Master volume control drives 4V RMS (front/rear) and 6V RMS (sub out). WARNING High-powered car audio systems sound pressure levels that exceed the threshold at which hearing loss may result. -
Page 5: Installation Guidelines
INSTALLATION GUIDELINES 1. Read this manual carefully and in its entirety before installing this equalizer. 2. Always disconnect the battery or remove the fuses for circuits you will be working on. 3. Check for clearance of any hazards such as hoses, heater core, or brake lines before mounting the equalizer to any panels in the vehicle. -
Page 6: Rear Panel Features
REAR PANEL FEATURES Power Connector 1. R R e e m m o o t t e e T T u u r r n n O O n n O O u u t t p p u u t t - This output is intended to be the remote turn on for the system amplifiers and has a built in delay. -
Page 7: Intiial Settings
FIGURE 1—REAR PANEL INTIIAL SETTINGS 1. Make sure the main Source 1 unit is connected to the Source 1 inputs, then adjust the main source units volume to just below maximum. 2. Adjust the Source 1 input gains (top of unit) to the minimum setting and the 2500 master volume control to the maximum setting. -
Page 8: Control Panel Features
CROSSOVER AND FILTER ADJUSTMENTS The crossover and filter gain adjustments can be performed two different ways, by using a piece of audio test equipment called an RTA (Real Time Analyzer) or by listening to a familiar piece of music. The RTA is most commonly used to achieve the flattest possible system response in preparation for a sound off competition. - Page 9 volume of the system and affects all line level outputs to the amplifiers. F F a a d d e e r r - To set the master volume/ fader control knob to the fader posi- tion, pull gently on it until a notched position is reached.
-
Page 10: System Diagram
SYSTEM DIAGRAM © 2002 Directed Electronics, Inc... -
Page 11: Specifications
SPECIFICATIONS Directed model 2500 Filter Frequencies Boost/Cut Crossover/Range Signal-to-Noise Ratio Frequency Response Maximum Output Voltage Output Impedance Gain (all filters set flat) Total Harmonic Distortion Stereo Separation Input Sensitivity Input Impedance Operating voltage/fuse Remote Out Size (H x W x D) ©... - Page 12 Directed Electronics, Inc. Vista, California 92083 www.directed.com Quality Directed products are sold and serviced throughout North America and around the world Call 800 274 0200 for more information about our products and services © 2002 Directed Electronics, Inc. - All rights reserved - G44520 05/02 The company behind this system is Directed Electronics, Inc.
Need help?
Do you have a question about the Model 2500 and is the answer not in the manual?
Questions and answers