Juniper BXOS 4.1 R2 - RELEASE NOTES 07-2010 Release Note page 13

7. Enter configuration mode using the following command:
cli@BX7000> con
8. Configure the gateway from the following prompt:
cli@BX7000#
To set the system to the factory default:
1. Reboot the system.
The prompt displays:
Press ESC Key to enter into Field diagnostics
2. Press the key.
Esc
The prompt displays:
Enter the password:
3. Enter the password as
Enter the password:
The system displays the following
1. Diagnostics Mode
2. Setup Mode
3. Exit and Continue
Enter the menu option number and press Enter key:
4. Enter the menu option number as 2 for the Setup Mode:
Enter the menu option number and press Enter key: 2
The system enters into the SIDX setup mode.
SIDX>
5. Set the system to the factory default using the
SIDX> factorydefault
The system requires a password to execute the command.
6. Enter the password as
Enter the password:
7. The system reboots with the default factory configuration.
8. After system reboot, access the gateway using the root account or CLI user
privileges.
9. Enter configuration mode using the following command:
cli@BX7000> con
10. Configure the gateway from the following prompt:
cli@BX7000#
For information about restoring the configuration file, see the BXOS
Configuration Guide.
In FRR set up with SAToP pseudowire, the primary and bypass tunnel statistics
are not updated after the traffic switches back to the bypass tunnel interface.
There is no workaround. [PR/446941]
message.
.
GetmeIn@7
options:
Boot Menu
factorydefault
to set the system to the factory default:
syrah
BXOS 4.1 R2 Software Release Notes
command:
Outstanding Issues
13