Advertisement
Dimp13292-Shower inst aX4
5/5/04
2:08 pm
DIMENSIONS
2
Page 3
218mm
LOW
AUTO
PRESSURE
RESET
COLD
LOW
HIGH
TEMPERATURE
UNPACKING AND IMPORTANT NOTICES / INSTALLATION
SECTION 1
Unpacking and important notices
Contents
Complete all plumbing connections
1 x Shower Unit
before making any electrical connections.
1 x Showerhead
1 x Flexible Hose
The outlet of the shower unit must only be
1 x Slider Rail Tube
connected to the hose and showerhead
1 x Slider Rail Brackets
supplied with the unit. Use of other
1 x Height adjuster
components will invalidate the warranty.
1 x Screw pack
1 x Soap dish
Always switch off at the isolating switch
1 x Showerhead key
when the shower is not in use.
IMPORTANT NOTICES
To comply with National Water Council
PLEASE READ BEFORE ATTEMPTING
bylaws a double check valve must be
TO INSTALL THE SHOWER UNIT
fitted where it is possible that the shower-
head may come into contact with used
1) The shower unit must be installed by a
water e.g. in the shower tray or bath.
suitably qualified person and conform
to IEE Regulations and National Water
Do not operate power tools in a wet envi-
Council Bylaws.
ronment. It is recommended that any power
tools operated in the bath or shower area are
2) The shower must only be connected
supplied via a Residual Current Device (RCD).
to a 15mm mains cold water supply.
WARNING! THIS APPLIANCE MUST BE EARTHED.
Do not connect the unit to the cold
water supply of a header tank.
This shower is for connection to a
230V-240V/50Hz mains electricity supply.
3) The minimum recommended running
water pressure to which the shower
SECTION 2
Installation
heater may be connected is 15lb/sq in
(1bar); running pressure of 8 litres/minute;
maximum static pressure recommended
Typical instantaneous electric shower
150lb/sq in (10 bar).
installation
4) The shower unit must not be fitted
where it may be exposed to frost, for
example in an outdoor shower area. The
shower must not be used if suspected of
being frozen. Please note: Frost damage
is not covered by the guarantee.
5) Do not use Plumbers jointing compound.
Use of plumbers jointing compounds
invalidates the guarantee.
Double pole heater switch wall mounted in
accordance with local authority regulations
Seperate permanently
connected supply
from consumer unit
Dimplex electric
Isolating
water heater
stop tap
Cold
water
mains
supply
3
Advertisement
