Configure Wpa-Personal (Psk) - D-Link Amplifi DIR-657 User Manual

Section 4 - Security
It is recommended to enable encryption on your wireless router before your wireless network adapters. Please establish wireless connectivity before
enabling encryption. Your wireless signal may degrade when enabling encryption due to the added overhead.
1.. Log into the web-based configuration by opening a web browser and
entering the IP address of the router (192.168.0.1). Click on.Setup.and then
click.Wireless.Settings on the left side.
2. Next to Security Mode, select WPA-Personal.
3. Next to WPA Mode, select Auto, WPA2.Only, or.WPA.Only. Use Auto if you
have wireless clients using both WPA and WPA2.
4. Next to Group Key Update Interval, enter the amount of time before the group
key used for broadcast and multicast data is changed (3600 is default).
5. Next to Pre-Shared Key, enter a key (passphrase). The key is entered as a
pass-phrase in ASCII format at both ends of the wireless connection. The
pass-phrase must be between 8-63 characters.
6. Click Save.Settings to save your settings. If you are configuring the router
with a wireless adapter, you will lose connectivity until you enable WPA-PSK
on your adapter and enter the same passphrase as you did on the router.
D-Link DIR-657 User Manual

Configure WPA-Personal (PSK)

87