Alinco EDX-2 Quick Start Manual

SCHEMATIC DIAGRAM
IOS
02
COD
CLE
vr_c
00
S.•2Sv
oscz
20 t N
A1-INCO INC.
Head office : Shin Dai Bldg 8F I -2-6 Dojimahana, Kita.ku
Osaka 530-0004 Japan
Phone : 06-4797-2136 Fax : 06-4797-2157
Email : export@alinco.co.jp http : m•m.alinco.com/
e-2#•
620* ezop • LOP
LEO
czoo
OOP • 'OP
c2•c cztc C z IC
24 p .or
C 22" (226 C22C •:220
LC09
G2P
LED
L" 06
C2SB C2SC
•OF IOP 2EZ
L EOM
R 27
vs
103 IOS
103 103 103
PRINTED
Copyright
EDX-2 AUTOMATIC
C2to CalC C27D
Alinco' s EDX-2 is an automatic antenna tuner that matches your transceiver to an antenna of over
001
3 meters in length ( 3.5MHz and above ), or over 12 meters in length ( 1.6MHZ and above ).
CBS
This manual contains information you should know before installing the EDX-2 and describes how
to set up, connect,
SPECIFICATIONS
• Frequency Range
Input power ( MAX )
• Input impedance
• Tuning Voltage
ENCLOSURE
The Following items are enclosed in the package of the EDX-2 :
( 1 EDX-2 itself
(2). U-bolts, 2 pcs.
(3). U-bolt plates, 2 pcs.
(4). Flat washers ( large ), 8 pcs.
(5). Flat washers ( small ), 4pcs.
(6). Spring washers, 8 pcs.
(7).
Nuts, 8 pcs.
(8). Hex bolts, 4 pcs.
Self-tapping screws, 4 pcs.
(10). Rubber cap, 1 pc.
CAUTION !
EDX-2 is designed
Warranty
DO NOT use this tuner when it is not grounded. You must ground the
tuner through
mounting plates for grounding ; the ground-terminal should be grounded
independently.
DO NOT use gas pipes for grounding.
DO NOT transmit
DO NOT touch the antenna, ground wire, or come close to the antenna
element while transmitting
IN JAPAN
position where you are sure it will not be touched.
Alinco, Inc.
PS 0251 B
ANTENNA TUNER
and operate.
3.5—30MHz ( with over 3 meter element
1.6—30MHz ( with over 12 meter element
200W P.E.P.
50
13.8V DC ±
to be used only with Alinco
is void when used with a product of other manufacturers.
the ground terminal before operating.
or tune without an antenna.
or tuning. Place the EDX-2 and antenna in a
MLINCO
)
)
HF transceivers.
DO Not use the