Finalizing The Cluster Conversion; Additional Information - Novell OPEN ENTERPRISE SERVER - CONVERSION GUIDE 12-2010 Manual

4 Transition the Transition end-user printing from NetWare to Linux.

Offline the NetWare iPrint cluster resource.

View the NetWare iPrint cluster load script's /DNSNAME value.

Configure DNS to resolve the /DNSNAME value to the IP address of the target Linux
cluster resource hosting the Print Manager.
NOTE: The propagation of the DNS change might take time, depending on your network.
DNSNAME is the address that the clients use to find the NetWare Print Manager. The
same DNSNAME is used to find the Linux Print Manager.

Update each of the Linux node
address.

Update the
/etc/opt/novell/iprint/conf/ipsmd.conf
the /DNSNAME.

Restart the Print Manager.
5 (Optional) Perform the post-migration steps as described in
ID Migration Steps
For detailed information about iPrint migration requirements, pre-migration configuration,
migration procedures, post-migration tasks, and troubleshooting, see
NetWare or OES 2 Linux to OES 2 SP3
Guide.

13.4 Finalizing the Cluster Conversion

After your OES 2 Linux iPrint setup is working as expected, finalize the cluster conversion, as
described in Section 4.3, "Finalizing the Cluster Conversion," on page

13.5 Additional Information

See the following Novell Support Technical Information Documents (TIDs) for more information
about migrating iPrint from NetWare to OES 2 Linux:

TID 7005448: Migrating an iPrint Cluster from NetWare to OES 2 (http://www.novell.com/
support/viewContent.do?externalId=7005448)

TID 7004455: iPrint Migration Best Practices (http://www.novell.com/support/
viewContent.do?externalId=7004455)
/etc/hosts
" in the OES 2 SP3: Migration Tool Administration
Linux" in the
files to resolve to the Linux iPrint cluster IP
PSMHostAddress value to
"Transfer ID" and
Guide.
"Migrating iPrint from
OES 2 SP3: Migration Tool Administration
32.
"Post Transfer
Novell iPrint 59