Page 3
Content in this manual may differ from the actual product or software. Trademarks ZTE and the ZTE logos are trademarks of ZTE Corporation. Android™ is a trademark of Google LLC. Other trademarks and trade names are those of their respective owners.
Page 4
Getting to Know Your Phone Earpiece Proximity & light sensor Front camera nano-SIM/ microSDXC card tray Volume key Power key Under-display fingerprint sensor Charging/USB Speaker Type-C jack...
Page 5
Back camera and flash NFC area Your phone supports 2.4 GHz and 5 GHz Wi-Fi.
Page 6
Setting Up Your Phone The nano-SIM card can be installed or removed while the phone is turned on. WARNING! To avoid damage to the phone, do not use any other kind of SIM cards, or any non-standard nano-SIM card cut from a SIM card. You can get a standard nano-SIM card from your service provider.
Page 7
2. Pull out the card tray. You can place a nano-SIM card into the card slot on the right side and a microSDXC card (optional) into the card slot on the left side, as shown. Note the notches and the shapes of the cards and the card slots. Carefully slide the tray back into place.
Page 8
You should fully charge the battery as soon as possible. WARNING! Use only ZTE-approved chargers and USB Type-C cables. The use of unapproved accessories could damage your phone or cause the battery to explode.
Page 9
2. Connect the charger to a standard AC power outlet. 3. Disconnect the charger when the battery is fully charged. NOTE: If the battery is extremely low, you may be unable to power on the phone even when it is being charged. In this case, try again after charging the phone for at least 20 minutes.
Page 10
For Your Safety General Safety Don’t make or receive handheld calls while Don’t use at petrol driving. Never text stations. while driving. Keep your phone at Your phone may least 10 mm away produce a bright or from your body while flashing light.
Page 11
Avoid contact with Avoid extreme anything magnetic. temperatures. Keep away from Avoid contact with pacemakers and liquids. Keep your other electronic phone dry. medical devices. Turn off when asked Do not attempt to to in hospitals and disassemble your medical facilities. phone.
Page 12
Radio Frequency (RF) Energy General Statement on RF Energy Your phone contains a transmitter and a receiver. When it is ON, it receives and transmits RF energy. When you communicate with your phone, the system handling your call controls the power level at which your phone transmits. Specific Absorption Rate (SAR) Your mobile device is a radio transmitter and receiver.
Page 13
* Please see body worn operation. Body Worn Operation Important safety information regarding radio frequency radiation (RF) exposure: To ensure compliance with RF exposure guidelines the phone must be used with a minimum of 5 mm separation from the body. Failure to observe these instructions could result in your RF exposure exceeding the relevant guideline limits.
Page 14
FCC RF Exposure Information (SAR) This phone is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the United States. During SAR testing, this device was set to transmit at its highest certified power level in all tested frequency bands, and placed in positions that simulate RF exposure in usage against the head with no separation, and near the body with the...
Page 15
Display Grant section of www.fcc.gov/oet/ea/fccid after searching on FCC ID: SRQ- A202ZT. For this device, the highest reported SAR value for usage against the head is xxxx W/kg, and for usage near the body is xxxx W/kg.
Page 16
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Page 17
transmitter. Distractions Driving Full attention must be given to driving at all times in order to reduce the risk of an accident. Using a phone while driving (even with a hands-free kit) can cause distraction and lead to an accident. You must comply with local laws and regulations restricting the use of wireless devices while driving.
Page 18
Always treat your phone and its accessories with care and keep them in a clean place. Keep the screen and camera lens clean. An unclean screen or camera lens may slow down the phone's reaction to your operations or interfere with the image quality. ...
Page 19
Do not change or replace the built-in rechargeable battery in your device by yourself. The battery can only be changed or replaced by ZTE or ZTE authorized service provider. Do not place the device or the battery in or near heating equipment, such as microwave ovens, stoves or radiators.
Page 20
If the battery damages or shows signs of swelling or leakage, please stop use immediately and contact ZTE or ZTE authorized service provider for replacement. Small Children Do not leave your phone and its accessories within the reach of small children or allow them to play with it.
Page 21
Antenna Do not touch the antenna unnecessarily. Normal Use Position When placing or receiving a phone call, hold your phone to your ear, with the bottom towards your mouth. Airbags Do not place a phone in the area over an airbag or in the airbag deployment area, as an airbag inflates with great force and serious injury could result.
Page 22
Do not grip the phone too tightly. Press the buttons lightly. Use the special features which are designed to minimize the times of pressing buttons, such as Message Templates and Predictive Text. Take frequent breaks to stretch and relax. Emergency Calls This phone, like any other wireless phone, operates using radio signals, which cannot guarantee connection in all conditions.
Page 23
Electrical Safety Accessories Use only approved accessories. Do not connect with incompatible products or accessories. Take care not to allow metal objects, such as coins or key rings, to contact or short-circuit the USB Type-C jack. Never puncture the surface of the phone with sharp objects. Connection to Vehicles Seek professional advice when connecting a phone interface to the vehicle electrical system.
Page 24
personal medical devices, such as pacemakers and hearing aids. Please consult your doctor and the device manufacturers to determine if the operation of your phone may interfere with the operation of your medical devices. Pacemakers Pacemaker manufacturers recommend that a minimum separation of 15 cm be maintained between a mobile phone and a pacemaker to avoid potential interference with the pacemaker.
Page 25
Aircraft Switch off your wireless device whenever you are instructed to do so by airport or airline staff. Consult the airline staff about the use of wireless devices onboard the aircraft and enable aeroplane mode of your phone when boarding an aircraft. Wi-Fi The device is restricted to indoor use only when operating in the 5150 to 5350 MHz frequency range.
Page 26
facilities, and areas where the air contains chemicals or particles, such as grain, dust, or metal powders. Blasting Caps and Areas Power off your mobile phone or wireless device when in a blasting area or in areas where signs are posted to power off “two-way radios”...
Page 27
GSM900: 33.0 dBm GSM1800: 30.0 dBm GSM1900: 30.0 dBm UMTS Band 1: 23.5 dBm UMTS Band 2: 23.5 dBm UMTS Band 4: 23.5 dBm UMTS Band 8: 23.5 dBm LTE Band 1: 23.5 dBm LTE Band 2: 23.5 dBm LTE Band 3: 22.5 dBm Maximum RF output power LTE Band 4: 23.5 dBm...
Page 28
EU DECLARATION OF CONFORMITY Hereby, ZTE Corporation declares that the radio equipment type ZTE 9047 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following Internet address: https://certification.ztedevices.com The device is restricted to indoor use only when operating in the 5150 to 5250 MHz frequency range.
Need help?
Do you have a question about the A202ZT and is the answer not in the manual?
Questions and answers