Advertisement
2) Diagram #2 shows the proper assembly order of spring and associated components.
3) Place all components (per diagram #2) into place.
4) Place base onto treadle and align screw hole openings in base to line up with holes in treadle bracket.
5) Place a int. tooth washer on 6-32 a 1/2" screw. Using the needle-nose pliers, hold the 6-32 x 1/2" Phillips
pan head screw by the head and insert from underside of treadle bracket. (The thread should stick up in the
inside of the pedal base) Replace washer and 5/16" nut. Repeat for three remaining mounting locations. Do
not tighten any of the four nuts yet.
6) Align and center treadle to base. This can be accomplished by setting the pedal assembly on its heel end,
pushing the treadle as far toward the toe end as possible and visually centering the treadle so it is not cocked
to the right or left. This is important so the shutter is located properly between the optics.
7) Tighten the four 5/16" nuts thoroughly.
8) Set the screw tightness on each side of the treadle. To accomplish this, place the 3/8" wrench on the nut
located on the inside of the treadle/bracket assembly. Tighten bolt all the way down and loosen it one half turn
to allow treadle to move freely. Repeat for opposite side.
9) Replace circuit board, four 1/4" nuts, two black plastic rings & two chrome jack nuts.
10) Insert battery snap through the slit in battery foam.
11) Perform sound test to verify wah setting is still within acceptable range.
12) Replace bottom cover and bottom cover screws.
13) Diagram #3 shows the assembled spring.
If you need further assistance, please call 1-800-284-5172
Bill Wenzloff ext 12
Chad Montrose ext 14
Advertisement
