Table of Contents
Advertisement
M O L B L O C / M O L B O X ™
C O N F I G U R A T I O N S
I N S T A L L A T I O N
A N D
Installation
UNPACKING AND INSPECTION
Removing From Packaging
All molbloc/molbox system components and accessories are delivered in corrugated containers with custom inserts or foam to hold
them in place. They are also enclosed in protective plastic bags within the containers.
Remove the components from the shipping containers and remove each element from its protective plastic bag. Retain the boxes
and inserts for possible reuse.
Inspecting Contents
Use Table 1 to determine which components are included in your system. Descriptions of the components' packaging and
accessories are below. Check that all items are present and have NO visible damage.
molbox1 is delivered with caps installed over the pressure connections and
communications ports on the rear panel. A piece of cellophane protects the front
panel and may be removed. The molbox1 accessory kit is placed inside the box
with molbox1. The Metering Valve Kits (see Section 2.1.2.6) and the AFMETCAL
Configuration Kit (see Section 2.1.2.7) may also be placed in this box. The
following items should be present in the molbox1 accessory kit:
• molbox1 molbloc Terminal (Ver. 5.00 and higher) Operation and
Maintenance Manual
• molbox1 Calibration Certificate
• Power Cord
• Four molbloc to molbox1 Pneumatic Lines with Quick Connectors
• Two molbloc to molbox1 Electrical Connection Cables
• molTools Utility Software Disk
• COMPASS for molbox for Windows Demo Version Software Disks
• Four Rubber Feet Caps
L O W
M A S S
F L O W
O P E R A T I O N
M A N U A L
m o l b o x 1
Page 3
C A L I B R A T I O N
S Y S T E M
S U P P L E M E N T
©2000-2008 DH Instruments, a Fluke Company
A F M E T C A L
Advertisement
Table of Contents
