Page 1
Model #CZFP1 ® Ceramic Fireplace Heater Features: •Realistic LED 3-D Flame Effect •Three Settings: High (1200 watts - 4095 BTUs) (600 watts) 3-D Flame Only •Fan Forced Air Circulation •No Venting Required •Stay Cool Composite Body •Safety Tip-Over Cutoff Switch •Safety Overheat Protection...
Page 2
SAVE THESE INSTRUCTIONS INTENDED USE: This product is intended for indoor residential and office use only, not for industrial or other commercial applications. Use only with electrical wiring that is in good working order and that meets applicable codes and ordinances. If you have any questions whether your wiring is adequate, consult a qualified electrician.
Page 3
WARNING: HOT SURFACES Do not touch body of heater when in use. This heater is hot when in use, to avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this heater. WARNING: FIRE HAZARD Heater has hot and arcing or sparking parts inside.
Page 4
USAGE: HEATER OPERATION: Always operate the heater in the upright position following all instructions and recommendations listed in this manual HEATER LOCATION: Place the heater in the area of the room that is coldest. HEATER CONNECTION: Plug heater directly into 120 volt A.C., 60 Hz wall outlet. Be sure plug fits tightly in outlet.
Page 5
IMPORTANT SAFETY FEATURES The power indicator light, located near the Power On/Off Flame Control switch, lights whenever the heater is turned on any setting to tell you that the heater is functioning properly. The heater is equipped with an automatic overheat protection device located inside the body of the heater.
Page 6
After 30 days, but within the warranty period, if the unit was purchased within the continental united States, return it, freight prepaid, to Comfort Zone® for repair or replacement. If the unit was purchased outside the continental united States, return the unit to the place of purchase. This warranty does not cover damage due to accidents, operation on other than 120 volts, 60 hertz, AC.
Need help?
Do you have a question about the CZFP1 and is the answer not in the manual?
Questions and answers