Download Print this page
American Standard 10-US-AS-3 Instruction Manual
American Standard 10-US-AS-3 Instruction Manual

American Standard 10-US-AS-3 Instruction Manual

Garbage disposer

Advertisement

Quick Links

Food Waste Disposer Instruction Manual
E-Mail: ConsumerService@Joneca.com
NOTE:
IMPORTANT:
CAUTION:
Record important disposer information here
Model Number*
*Above information appears on the label affixed to the bottom of the disposer. For your convenience,
write down the model and serial number prior to installation.
Warranty. Staple receipt or proof of purchase to this manual for easy reference.
IMPORTANT SAFETY INSTRUCTIONS
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK OR INJURY
TO PERSONS. SAVE THESE INSTRUCTIONS.
WARNING – When using electrical appliances,
basic precautions should always be followed,
including the following:
1. Read all instructions before using the appliance.
2. To reduce the risk of injury, close supervision is
necessary when an appliance is used near children.
3. Do not put fingers or hands into a waste disposer.
4. Turn the power switch to the off position before
attempting to clear a jam or remove an object from the
disposer.
5. When attempting to loosen a jam in a waste disposer,
use a long wooden object such as a wooden spoon or
the wooden handle of a broom or mop.
6. When attempting to remove objects from a waste
disposer use long-handled tongs or pliers. If the
disposer is magnetically actuated, non-magnetic tools
1-833-776-0014 - Customer Service
Monday through Friday, 8 am to 5 pm PT (English and Spanish) www.joneca.com
This Food Waste Disposer has been designed to operate on 110-120 Volt, 60 Hz
exclusively. Using any other voltage or Hz adversely affects performance.
Read all instructions thoroughly. Keep this guide for future reference.
Be sure to review SAFETY INSTRUCTIONS FIRST PERTAINING TO A RISK OF
FIRE, ELECTRICAL SHOCK OR INJURY TO PERSONS before using disposer.
Warranty is non-transferable.
Having Problems? Don't go back to the store.
Call us toll-free at 1-833-776-0014 for assistance.
M-F 8:00am-5:00pm PST English & Spanish
Serial Number*
Proof of purchase is required for
should be used.
7. To reduce the risk of injury by materials that may be
expelled by a waste disposer, do not put the following
into a disposer: clam or oyster shells; caustic drain
cleaners or similar products; glass, china or plastic;
large whole bones; metal, such as bottle caps, tin
cans, aluminum foil or utensils; hot grease or other
hot liquids; whole corn-husks.
8. When not operating a disposer, leave the stopper in
place to reduce the risk of objects falling into the
disposer.
9. DO NOT operate disposer unless splash guard is in
place.
10. For proper grounding instructions see the ELECTRICAL
CONNECTIONS portion of this manual.
The receptacle to which this appliance is
connected must be controlled by a switch.
1
®
IM-ASD-AMZ-241

Advertisement

loading
Need help?

Need help?

Do you have a question about the 10-US-AS-3 and is the answer not in the manual?

Questions and answers

Summary of Contents for American Standard 10-US-AS-3

  • Page 1 ® Food Waste Disposer Instruction Manual 1-833-776-0014 - Customer Service E-Mail: ConsumerService@Joneca.com Monday through Friday, 8 am to 5 pm PT (English and Spanish) www.joneca.com NOTE: This Food Waste Disposer has been designed to operate on 110-120 Volt, 60 Hz exclusively.
  • Page 2 1. REMOVAL OF OLD UNIT TYPICAL INSTRUCTIONS, YOUR MODEL MAY VARY. Before starting this step, turn off electrical power at the circuit breaker or fuse box. Unplug disposer. NOTE: If your old mount is the same type (3-Bolt Mount) as the mount on your new disposer and you wish to continue using the old mount, just remove your old disposer as shown below in parts 1A,1B, &...
  • Page 3 2. INSTALLATION OF MOUNTING ASSEMBLY READ CAREFULLY AND COMPLETELY BEFORE STARTING STOPPER NOTE: As the mounting assembly is properly assembled at the factory, please pay close attention to the REMOVABLE SPLASH GUARD order of the mounting system parts. LOWER MOUNT RING SINK FLANGE FIBER GASKET DISHWASHER INLET...
  • Page 4 (2. CONTINUED) INSTALLATION OF MOUNTING ASSEMBLY A. The Cushion Ring and the Lower Mount Ring will remain attached to the disposer during installation. Take apart the other parts of the mounting assembly by rotating the Lower Mount Ring (J on page 3) clockwise until the Lower Mount Ring Tabs slide off from the Upper Mount Ring ramp (A1).
  • Page 5 3. DISHWASHER CONNECTION PREPARATION If you are utilizing a dishwasher, complete the following procedure. KNOCK OUT PLUG Using a blunt instrument (steel punch or wooden dowel), knock out entire plug. Do not use a screwdriver or sharp instrument. (When knockout plug falls into disposer, you may remove it or grind it up when the disposer is used.
  • Page 6 6. DISCHARGE ELBOW & DISHWASHER CONNECTIONS A. Connect bottom of the elbow by tightening the slip nut (see 6A). AIR GAP If you are connecting to a dishwasher, see B. If not, make sure all plumbing RUBBER connections are tight and in accordance HOSE with all plumbing codes and ordinances.
  • Page 7 PERMANENT WIRE INSTALLATION INSTRUCTIONS FOR WASTE DISPOSERS NOT EQUIPPED WITH A GROUNDED PLUG-IN POWER CORD. WARNING: Electric Shock Turn off power before installing or servicing disposer. All GROUNDING: This disposer must be connected to a wiring must comply with local electrical codes. grounded, metal, permanent wiring system;...
  • Page 8 PERMANENT WIRE INSTALLATION INSTRUCTIONS-ILLUSTRATED 1. After turning off power 2. Using a flathead screwdriver 3. Using wire cutters, cut black (or supply, unbolt two nuts or needle nose pliers, remove brown) wire and white (or blue) and remove end plate. clip from strain relief portion of wire near the connectors.
  • Page 9 8. OPERATING INSTRUCTIONS The Anti-Jam Swivel Impellers make a clicking and are more easily thrown away with other trash. Do sound as they initially swing into place. This not be alarmed that the disposer slows down while indicates normal operation. grinding.
  • Page 10 (6C). WARNING: This is not a toy. Keep uninstalled Silver Guard® away from children. REGISTER YOUR AMERICAN STANDARD DISPOSER Register to enable us to provide the best service possible. Supplied By...
  • Page 11 Warranty is non-transferable. 1. WARRANTY: Joneca Company, LLC warrants this American Standard disposer, when installed in the United States to be free from defects in workmanship and material during the warranty period. This warranty sets forth our overall warranty commitment. We will not assume, nor authorize any person to assume for us, any other liability in connection with the sale of our products.

This manual is also suitable for:

10-us-as-710-us-as-12-sl