LG LMHM2017ST Installation Instructions Manual page 6

PAR TS, TO 0 L S, MATER IA LS
You will need the following tools and materials for the installation:
Carton or other heaw material for covering the counter top.
Clear Tape
(for taping the templates to the wall)
Stud Finder
Saber Saw
(for cutting vent holes for roof
or wall venting)
Phillips Screwdriver
Pencil
Flat Blade Screwdriver
I
I
Keyhole Saw (for the power cord hole)
Electric Drill
3/8" and 3/4" wood drill bits
1/2" and 3/16"
drill bits ---,=,=====.
Measuring Tape
Plumb Line
Small Side Cutters or Tin Snips
Duct Tape
Gloves
Caulking Gun
o If you have brick or masonry walls, you will need special hardware and tools.
o The ductwork you need for the installation is not included. All wall and roof caps must have a back-draft damper.
(Shown on page 5).
-6-