Well RC-AC-WHIFF-WL Instructions For Use

UNIVERSAL A/C REMOTE CONTROL
Our product is available for: GREE (YBOF2), Mitsubishi 388, Midea, Toshiba, Chunlan, Haier, HuaLING
etc. If it's not working, please try to operate it with one of the methods below:
1. Switch on the power of the air condition manually, align the remote control with the receiving window
2. Long press the CODE button until the air condition begins to automatically run with a voice of tick,
and then release the button, and the setup is finished.
B> Digital auto searching for the available type
1. Switch on the power of the air condition manually, align the remote control with the receiving window
2. Press and hold the "SET" button for 6 seconds until the type code has changed (+1), now it's in the
mode of fast searching for the available type. Checking the status of your air condition and press
"OK" button to finish the searching when the air condition starts automatically.
3. Check the function of the buttons whether working or not (except the TEMP+, TEMP-, TIME ON,
TIME OFF, SET buttons). Press the "OK" button to finish if there is no problem and the code is
effective, if not, press "SET" button to keep on searching.
1. Switch on the power of the air condition manually, find out the type of your air condition and the first
code from the code table. Take HAIER as an example.
2. Press and hold the "SET" button for about 3 seconds until the type code is flickering in the window,
then press "TEMP+" button until the code you need is on the window and flickering, the air condition
3. Press "OK" button and then the code of the type will stop flickering.
4. Check the function of the buttons on the remote control to make sure there is no problem. The setup
is finished if there is no problem. If not, repeat the step 2-3.
1. Switch on the power of the air condition manually, align the remote control with the receiving window
2. Press and hold the "SET" button for about 3 seconds until the type code is flickering in the window,
then press "TEMP+" button one time . Checking the status of your air condition and press "OK" button
to finish the searching when the air condition starts automatically.
"SET" "WIND" button at the same time and hold about 3 seconds to restore to factory settings.
Press the +
Some of the remote control have the functions below
1. FAST COOLING, FAST HEATING button
The air condition will be set to the cooling mode by pressing the "FAST COOL" button, the temperature is
The air condition will be set to the heating mode by pressing the "FAST HEAT" button, the temperature is
* In the mode of heating, press the *E A Heating" button to start the electrical heating function. This
Press the "CLOCK" button (about 3 seconds) to get in the mode of clock setting and then the clock is
flickering, adjust the time by pressing the "TÉMP+" button and the "TEMP-" button. Press the "CLOCK"
Equipped with the original remote control timing function, the timing indicator light of the air condition will
light up after pressing the "TIME ON" or "TIME OFF" button, and it means that the air condition is working
The combination code has no timing function when it is switched on, please find the appropriate type
according to the set-method (one of the A B C D) in the Instruction Manual.
* The TIME ON function of some types is only available in the shutdown mode.
INSTRUCTIONS FOR USE
Default Function
Setting of The Remote Control
A> Brand point to point fast searching
of the air condition.
Button Brand Corresponding Table
of the air condition.
C> Input the code manually
will start up if the code is right.
D> Searching the code manually
of the air condition.
Restore to factory settings
(refer to the panel of the remote control)
21°C, strong wind, automatic direction.
27°C. strong wind, automatic direction.
function is suitable for some models.
2. Set the CLOCK function
button again to exit.
3.TIME ON/OFF function
in the timing status.
Note: