Waterford Blaze WF3000 Assembly Instructions

ASSEMBLY INSTRUCTIONS
D
Diagram 1
A
B
C
F G
E
Diagram 2
Blaze 12" Rechargeable Table Lamp
Item # WF3000
NOTICE:
Inspect item carefully before attempting to install. If there is
any damage or obvious defect, do not install. Item may not
be returned once it has been installed.
1. Carefully remove all parts from the box. Place on a clean,
soft surface.
2. Remove finial (A) from fixture (C).
Install shade (B) to fixture (C) and secure with finial (A).
3.
4. For best results fully charge battery before use.
5. Test the lamp.
Dimmer switch operation: Touch dimmer (D) to adjust
between high, medium, low and off settings (see diagram 1).
CHARGING INSTRUCTIONS:
1. Install plug (G) to adapter (F) as shown in diagram 2.
NOTE: CE, SAA, UK & CCC plug adapters included.
Connect USB-C (E) to adapter (F) and fixture, then plug
2.
into electrical outlet.
NOTE: For convenience, USB-C to USB-A adapter is
included.
USB TYPE C
CARE INSTRUCTIONS:
1. Clean only with a soft dry cloth or feather duster. Do not
use abrasive or chemical agents.
2. Battery disposal should be in compliance with any local
regulations that address the disposal of hazardous materials
and the following or equivalent: "Do not incinerate."
USB TYPE A