Safety Instructions CAUTION Please read these important safety instructions carefully IMPORTANT NOTES Before turning on the power for the first time, make sure the power cord is properly installed. These instructions should be retained for future reference. • Avoid installing the unit in locations described below: •...
Page 3
Thankyou INTHE BOX • Rothdock • Receiver • Remote Control Thank you for choosing the Rothdock. • Power Supply Adapter (x2) • Extension cable - 3.5mm We have tried to make this product as simple Line-in to RCA and effective as possible, utilising wireless •...
Remote Control 1 Press and hold to toggle the Rothdock between Standby and On mode. Press once to play or pause a song. 2 Press to temporarily mute the volume. Press again to resume volume level 3 Press to move up or down through the Menu 4 Press to increase/decrease volume 5 Return to the previous Menu screen 6 Select a Menu item...
Rear Connections ''The best revenge is massive success" Frank Sinatra On/Off Power 7V 700mA Adapter ••• ••• ••• For other audio devices such as MP3/ Mobile Phone or MiniDisk Player. Plug-in via 3.5mm mini Jack...
Page 6
3.5 mm line-in cable or RCA connector to the audio input of any amp systems. • Place your iPod/iPhone into the dock and press down gently until it is fully seated in the dock connector. • Switch on the Rothdock by pressing the on/off button at the back. The led light at the front of the dock will glow red.
Page 7
3. The volume may set too low? Press and hold the 11+" button on the remote control and check if the Amp's volume to the right position. Also check the iPod/iPhone sits correctly in the docking station. If you are using an alternate audio source such as CD player, make sure that the device is correctly connected to the Rothdock.
Page 8
Matter of fact it's all dark." Pink Floyd www.rothaudio.co.uk Apple, the Apple logo and iPod are trademarks of Apple Computer Inc, registered in the u.s. and other countries Roth and the Roth brand are registered trademarks worldwide...
Page 9
A) Turn on both dock and receiver with the receiver set up with amp/speakers. Use a pin to press the reset button on the "dock which is located 3cm behind the IPod connector for around 4 seconds until the LED starts to blink fast and then release the button.
Page 10
Problem 2- your RothDock and Wireless LAN are on the same frequency set and won't both work at the same time. Solution 2 -- Follow the steps below to change the frequency on which your RothDock works A) There are 11 channels in the wifi system we use. When the RothDock and the wireless access point are using the same channel there can be interference.
Need help?
Do you have a question about the AAV-ROTHDOCK - Roth Audio RothDock Wireless and is the answer not in the manual?
Questions and answers