Advertisement
Quick Links
Salter AIRE
Instruction Manual
Part No: 8350-1 / 8352-1 / 8353-1
Thank you for selecting the Salter AIRE
Compressor. Salter Labs is an innovative, industry-
leading manufacturer of respiratory
care devices. Please contact your local Salter Labs
dealer for information about additional products.
SAVE THESE INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USE.
Contents
Important Safeguards................................................ 1
Introduction..............................................................
Product Description................................................... 3
Operation..................................................................
Cleaning....................................................................
Storage.....................................................................
Maintenance.............................................................
Expected Service Life ................................................ 8
Troubleshooting........................................................ 9
Specifications........................................................... 10
Accessories............................................................... 11
Appendix A..............................................................
1. Important Safeguards
NOTE, CAUTION, WARNING, AND SYMBOLS:
Important information is highlighted by using the following:
NOTE
Indicates information that user should pay special
attention to.
CAUTION
Indicates correct operating or maintenance
procedures in order to prevent damage to or destruction of
the equipment or other property.
WARNING
Indicates potential danger that requires correct
procedures or practices in order to prevent personal injury
800987 Rev H (Side 1)
Compressor
Elite
Elite
.
™
2
4
5
6
7
12
.
Advertisement
Related Manuals for Salter AIRE Elite
Summary of Contents for Salter AIRE Elite
-
Page 1: Table Of Contents
Thank you for selecting the Salter AIRE Compressor. Salter Labs is an innovative, industry- leading manufacturer of respiratory care devices. Please contact your local Salter Labs dealer for information about additional products. SAVE THESE INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USE. - Page 2 Symbols: Off, disconnection from the mains On, connection to the mains Alternating Current (AC) ～ Protected against solid foreign objects having a IP2X diameter of 12.5 mm and greater. No protection against vertically falling water drops. Keep dry! Attention Class II Refer to instruction manual/ booklet “BF”...
-
Page 3: Introduction
2. Introduction 2.1 Intended Use Elite The Salter AIRE Compressor System is intended to provide a source of compressed air for aerosol therapy. It is used in conjunction with a jet (pneumatic) nebulizer to produce medicated aerosols for inhalation by pediatric and adult patients with respiratory symptoms. -
Page 4: Product Description
4.1 Daily Use Operation CAUTION The Salter AIRE Elite Compressor System is designed for intermittent use only. Do not operate it continuously for more than 30 minutes for a single use without turning it off and following a cooling period for least 30 minutes. -
Page 5: Safety Overload
Attach the other end of the tubing into the air-inlet connector founded at the bottom of the nebulizer cup. Elite Turn on the Salter AIRE Compressor by pressing the power switch to the I (ON) position and begin treatment. -
Page 6: Storage
Salter Labs authorized ® service representative. There are no serviceable parts inside the unit. Contact your Salter Labs dealer or authorized service center if your unit needs repair. WARNING Do not tamper with or attempt to repair the device. -
Page 7: Specifications
Transport: 10% to 90% RH non-condensing Atmospheric Operation: 700-1060 hPa Pressure 11. Accessories Model Description 8501-1-2 Salter AIRE Elite Replacement filters 8258-0-1 Compressor Carrying bag 8660 NebuTech® Nebulizer – Reusable 8960 NebuTech Nebulizer – Disposable 8967 NebuTech Nebulizer with Pediatric Mask... -
Page 8: Appendix A: Emc Information
8906 Nebulizer with Pediatric Mask 8924 Nebulizer with Adult Mask 12. Appendix A: EMC Information Guidance and Manufacturer’s Declaration- Electromagnetic Emissions: This device is intended for use in the electromagnetic environment specified below. The user of this device should make sure it is used in such an environment. Emissions Electromagnetic Environment- Compliance... - Page 9 the relative humidity should be at least 30%. ±2kV for ±2kV for Electrical fast power Mains power quality power supply transient/ supply line should be that of a line burst ±1kV for typical commercial or ±1kV for IEC61000-4-4 input/out hospital environment. input/out line line ±...
- Page 10 Recommended separation distances between portable and mobile RF communications equipment and this device: This device is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The customer or the user of this device can help prevent electromagnetic interference by maintaining a minimum distance between portable and mobile RF communications equipment (transmitters) and this device as recommended...
- Page 11 Guidance and Manufacturer’s Declaration - Electromagnetic Immunity: This device is intended for use in the electromagnetic environment specified below. The user of this device should make sure it is used in such an environment. Immunity IEC60601 Compliance Electromagnetic Environment- Test test level Guidance Portable and mobile RF...
- Page 12 Manufacturer’s declaration-electromagnetic immunity Test specifications for ENCLOSURE PORT IMMUNITY to RF wireless communications equipment The 9R-029003(8353-1) is intended for use in the electromagnetic environment (for home healthcare) specified below. The customer or the user of the 9R-029003(8353-1) should assure that it is used in such an environment. Pulse 380 –...
- Page 13 30 Spur Drive 30 Spur Drive El Paso, TX, 79906 USA El Paso, TX, 79906 USA Phone: 1-800-421-0024, 1-800-235-4203 Toll-Free Fax: 1-800-628-4690 E-mail: customercare@salterlabs.com www.salterlabs.com 2797 Authorized Representative in the E.U.: MT Promedt Consulting GmbH Altenhofstrasse 80 D-66386 St. Ingbert, Germany NOTE Consult distributor(s) or EU representative(s) for additional technical documents.
Need help?
Do you have a question about the AIRE Elite and is the answer not in the manual?
Questions and answers