Star TSP100IIILAN Easy Setup Manual

Introduction
This manual describes the setup procedures for the TSP100IIILAN. It also describes the connection
settings to be made when using a LAN with a DHCP server. If you would like to know how to
install the utility software or driver, when the network used does not have a DHCP server, or setup
and connection does not proceed smoothly, refer to the online manual for the TSP100IIILAN.
Check the Supplied Accessories
TSP100III
Set Up the Printer
1
Connect the LAN cable
Connect the LAN cable included with the printer to
the LAN connector of the TSP100IIILAN
connect the other end of the cable to the router
2
Inserting a Roll of
Paper
Push the cover opening lever

open the rear cover .
2
1

When using a paper roll with 58 mm width,
install the supplied paper guide on the
printer.
To change the paper width, the memory
switch must be set. Refer to the online
manual for details.
Easy Setup Guide
Power Cord* Paper Roll Guide
LAN Cable Roll Paper
 , and then
 .
Insert a roll of paper in the direction shown in

and then
the illustration.
Pull the end of the paper out straight
push down both sides of the printer cover to

close .
3
If any of the package contents are missing or damaged, contact the dealer where the
product was purchased.
*Accessories vary depending on the region where the printer was purchased.
This Manual
Easy Setup Guide
Switch Cover

, and
4
TSP100IIILAN
TSP100IIILAN online manual
www.star-m.jp/
tsp100iiilan-oml.html
Safety Instructions Holder Plate
Rubber Feet
2
1
3
Turn ON the Main Unit
Power
Connect the included power cable to the inlet
on the back side of the TSP100III
plug of the power cable to the outlet
2
Turn on the power to the TSP100III
check the LED (blue) to light up
O
O F
F
I
O N
3
 If your POS software requires a static IP
address, please continue to next section
"Assigning a static IP address".
Screws(2)

. Connect the

.
1

, and

.
4