Installing And Configuring Oracle9I Rac; Installation And Configuration Procedure; Setting Up A Compatibility Environment; Installing Libraries - Red Hat GFS 6.0 - INSTALLING AND CONFIGURING ORACLE9I RAC Manual

Installing and Configuring Oracle9i RAC
This chapter describes how to install and configure Oracle9i RAC for use with Red Hat GFS 6.0, using
the sample cluster described in Chapter 1 Overview. This chapter consists of the following sections:
Section 3.1 Installation and Configuration Procedure
•
Section 3.2 Setting Up a Compatibility Environment
•
Section 3.3 Preparing Oracle Nodes
•
Section 3.4 Installing and Configuring Oracle Components
•
Section 3.5 Creating an Oracle Database
•
3.1. Installation and Configuration Procedure
Installing and configuring Oracle 9i RAC consists of the following steps:

1. Setting Up a compatibility environment

2. Preparing Oracle nodes
3. Installing and configuring Oracle components
4. Creating an Oracle database
3.2. Setting Up a Compatibility Environment
Setting up a compatibility environment consists of installing libraries and setting up GCC.

3.2.1. Installing Libraries

The following compatibility libraries are required on your system to install Oracle Database 9.2:
• compat-gcc
• compat-libstdc++
•
compat-libstdc++-devel
• compat-gcc-c++
1. Check to see if the libraries are installed by running the
# rpm -q compat-gcc compat-libstdc++ compat-libstdc++-devel compat-gcc-c++
2. Install any missing libraries using
3. Proceed to Section 3.2.2 Setting Up GCC.
.
up2date
Chapter 3.
command as follows:
rpm -q