Red Hat DIRECTORY SERVER 8.0 Installation Manual page 58

Chapter 4. Setting up Red Hat Directory Server on HP-UX 11i
Updating adm.conf . . .
Updating admpw . . .
Registering admin server with the configuration directory server . . .
Updating adm.conf with information from configuration directory server . . .
Updating the configuration for the httpd engine . . .
Restarting admin server . . .
The admin server was successfully started.
Admin server was successfully reconfigured and started.
Exiting . . .
Log file is '/tmp/setupul88C1.log'
When the setup-ds-admin.pl script is done, then the Directory Server is configured and running.
To log into the Directory Server Console to begin setting up your directory service, do the following:
1. Get the Administration Server port number from the Listen parameter in the console.conf
configuration file.
grep \^Listen /etc/dirsrv/admin-serv/console.conf
Listen 0.0.0.0:9830
2. Using the Administration Server port number, launch the Console.
/opt/dirsrv/bin/redhat-idm-console -a http://localhost:9830
NOTE
If you do not pass the Administration Server port number with the redhat-idm-console
command, then you are prompted for it at the Console login screen.
50