Changing The Port - Red Hat DIRECTORY SERVER 2.0 - GATEWAY Introduction Manual

Configuring the DSML Gateway
Edit the value of the
3.
access.
For example, to change the default bindDN
uid=fred,ou=people,dc=example,dc=com
BindDN=anonymous
Edit the value of the
4.
password for authentication to the directory to keep access controls functioning.
Change the line which reads
Restart the gateway.
5.
If the gateway is configured with the default parameters, this is done by restarting the
server:

Changing the Port

Edit the value of the
that this port number is not used by another application.
Stop the gateway.
1.
If the gateway is configured with the default parameters, this is done by stopping the
server:
Open the
2.
The recommended way to change the port number is by running the
3.
the activation script to save changes and and then the
change the port number. Any typos or errors caused by manually changing this
parameter will prevent the gateway and/or Admin Server from restarting; running the
activation script avoids this problem.
However, to change the port number manually, edit the value of the line that reads
ServerPort="4456"
that is not in use by any other application.
For example, to change the port from
to
Restart the gateway.
4.
If the gateway is configured with the default parameters, this is done by restarting the
server:
8 Red Hat Directory Server DSML Gateway • February 2005
BindDN
to
BindDN=uid=fred,ou=people,dc=example,dc=com
BindPW
./start-admin
ServerPort
./stop-admin
file in the
server.xml
to reflect the port you wish to use. Remember to select a port
ServerPort="5564"
attribute to reflect the user for whom you are allowing
anonymous
attribute. The password must be the same as the
to
BindPW= BindPW=foo
attribute to reflect the server you wish to use. Be sure
/clients/dsmlgw/conf
to port
4456
.
to
, change the line that reads
.
directory.
-u
-i -p portNumber
, edit
5564 ServerPort="4456"
.
utility with
utilities to