Advertisement
3300 Superwideband remote
INSTALLATION OF RADAR ANTENNA
Mount the antenna to the vehicle such that the ANTENNA window
is facing the road surface, sky, right or left of the vehicle, and the
reflector has an unobstructed view of the road ahead.
This side facing
rearward traffic
Antenna window
Signal
Radar antenna mounted(vertical) with 45º Reflector.
Mounted in this position, radar signals are reflected into the
ANTENNA window.
10/4/00
9:38 AM
Page 13
10
MAKING THE CONNECTION
Antenna Cable To Control Panel
Once the antenna is installed, run the cable along the inside of
the vehicle or under it to the engine compartment. If using the
latter, find a location in the firewall where other wires (or the
speedometer cable) enter the passenger compartment and
feed the stereo jack connection through. Be careful not to
interfere with or disconnect other wires, cables, or mechanical
systems of your vehicle while routing the antenna cable. Also,
keep the antenna cable away from any areas in the vehicle that
may become hot. Four cable ties are provided to secure the
antenna cable at various points on the vehicle.
Engaging SWRA
To engage the rear radar antenna:
1.Unplug power cable from the console or turn vehicle off if
console is wired to a switched 12 volt source.
2. Plug the stereo jack connector (straight ended cable) at the end
of the rear antenna cable into the RADAR 2 port on the back of the
control panel.
3. Reapply power. Display reads:
R2
Press Dark for Yes or City for No.
4. When radar is received from the rear the display reads:
K*
11
ON?
9
Advertisement
