DMP Thinline Icon 7360INT Installation Manual

7360INT/7363INT Thinline Series Icon Keypads
Description
The DMP Thinline™ Series Icon Keypads offer flexible features and functionality in a stylish design. The 7300 Series
provides an easy to understand icon display to assist users when arming and disarming a series panel set-up as an
All/Perimeter or Home/Sleep/Away system. The icons
provide immediate recognition of any system alarm as well
as system status.
The Model 7360INT provides three 2-button Panic keys,
backlit keyboard with easy-to-read lettering and an internal
speaker. The Thinline logo is also backlit.
Card Reader
The Model 7363INT also provides a built-in proximity reader
designed to read standard HID proximity credentials. When
a proximity credential is presented to the internal reader, a
beep tone is heard to provide an audible acknowledgement
of the credential read.
Proximity Credentials Compatibility
DMP Keypads with internal proximity readers are compatible with most standard 125Khz Prox credentials
available from HID and all DMP proximity credentials. DMP Keypads are not compatible with iClass or other non-
HID credentials. There are custom and non-standard credentials from HID that are not
compatible with DMP proximity keypads. When using HID cards that have not been
purchased directly from DMP, thoroughly test the application fully before installation. DMP
does not guarantee compatibility with credentials not purchased from DMP.
Installing the Keypad
All DMP keypad housings are designed to easily install on any 4" square box, 3-gang switch
box, DMP 695 and 696 backbox, or flat surface. Figure 1 shows the keypad housing base
mounting hole locations.
Remove the Cover
The keypad housing is made up of two parts: the front, which contains the circuit board
and keyboard components and the base. Use the following steps to separate the keypad
front and base.
1. Insert a flat screwdriver into one of the slots on the bottom of the keypad and
gently lift the screwdriver handle toward you while pulling the halves apart.
Repeat with the other slot.
2. Using your hands, gently separate the front from the base and set the front and
components aside.
Harness Wiring
Figure 1 shows wiring harness assignments. Observe wire colors when connecting the Red, Yellow, Green and Black
wires to the keypad bus. When wiring directly to the panel terminals, connect Red to panel terminal 7, Yellow to
terminal 8, Green to 9 and Black to panel terminal 10. The 7360INT and 7363INT keypads are supplied with a 4-wire
harness for panel keypad bus connection. Since all 7300 Series keypads operate together on the Keypad bus using the
same address, there is no address option to set.
INST ALLA TION GUIDE
Backlit Logo
and Proximity
Antenna
Thinline™ Series Icon Keypad
Icon Display
Select Keys
COMMAND Key
Back Arrow Key
Shortcut and Digit keys
Building Wall
Thinline
Keypad
Lift screwdriver
handle up
toward you to
separate keypad
cover from base.