Learniture Accent Series Manual

Shapes Accent Collaborative Legs
Model #: 13078
WARNING:
Adult Assembly Required. Two adults recommended.
- Contains small parts, sharp points and edges.
- Do not stand, sit, kneel, climb, or lean on table for support.
- Do not pull or drag table across the floor.
- To move table, clear surface and lift table with two adults.
- Never leave children unattended.
- Do not place unit near high heat or moisture.
- Adult supervision recommended.
TOOLS INCLUDED
Hex Tool (1) Wrench (1)
TOOLS NEEDED
Phillips Screwdriver Rubber Mallet
A
Upper Leg Support (4)
E
1
Slide the base plate of the Upper Leg Support (A) into the receiver plate,
until the three pilot holes on the table are aligned and visible through the
corresponding holes on the leg base plate.
The fit should be tight and may require the use of a rubber mallet to
properly seat the leg base plate into the receiver plate. If needed, the
receiver plate screws may be loosened to provide additional clearance.
Re-tighten once the leg is installed.
Install each Upper Leg Support (A) onto the Table Top with
three Phillips Screws (C) using a Phillips screwdriver.
Do not use power tools.
(optional)
Parts List
BEFORE ASSEMBLING, MAKE SURE YOU HAVE ALL THE PARTS
B Lower Leg Extension (4)
Phillips Screws (12)
Use a Phillips
Screwdriver
Install Upper Leg Supports into Receiver Plates
C
Glide (4) D
Use the
Wrench
F
Table Batch ID Sticker
Caster (4)
Use the
Wrench
Hex Screws (8)
Use the
Hex Tool
See Next Page