Jabra EASYGO FOR PC User Manual page 9

Redial last number*
- Double tap the answer/end button when the headset is on and
not used .
Adjust sound and volume*
- tap the volume up or down to adjust the volume .
Mute/un-mute
- to mute, press both volume up and down at the same time .
a low beep alert plays during a muted call .
- to un-mute, tap either of the volume buttons .
Call waiting and placing a call on hold*
- this lets you put a call on hold during a conversation and
answer a waiting call .
- Press the answer/end button once to put the active call on
hold and answer the waiting call .
- Press the answer/end button to switch between the two calls .
- tap the answer/end button to end the active conversation .
HOW tHE StatUSDISPLaY™ WOrKS
Indicates if your headset is connected to your
Bluetooth®
phone
Indicator
- Solid light means headset is connected to your
- Flashing light means headset is in 'pairing mode'
Indicates battery level and if headset is turned ON
battery
Indicator
- Green light indicates that the headset has more
- red light indicates that the headset has less than
to save battery the Jabra StatusDisplay™ is turned off after 3 seconds .
Get an instant status from the Jabra StatusDisplay™ by a tap on any
button on the headset when you are not on a call .
* Phone dependent / For use with PC, Jabra PC Suite needs to be installed and
running on PC
phone
and ready to be connected to a new phone
than 30 minutes of talk time remaining
30 minutes of talk time remaining
Jabra EaSYGO – FOr PC
8