Front Panel Connector (J27); Cmos Reset (Jp3); Promise Controller (Jp4); Onboard Ati Rage Xl (Jp1) - TYAN TRINITY I845E Manual

2.3 – Front Panel Connector (J27)
Your chassis will usually come with connectors to install onto the motherboard, such as HDD and
Power LEDs. The Front Panel Connector has been implemented for such purposes.
1 2
3 4
1,3: Hard drive LED
5 6
2,4: Power LED
7 8
5,7: Reset Switch
6,8: Power Switch
9 10
11,13,15,17: InfraRed
11 12
12,14,16,18: Speaker Switch
13 14
15 16
17 18
2.4 – CMOS Reset (JP3)
1,2: Default
1
2,3: Clear CMOS
2
Connect pins 2 and 3 together to reset the CMOS settings in case an incorrect setting
3
causes system instability or you have forgotten your system/setup password or have
just flashed your BIOS.
Power off the system and disconnect the power supply.
- Close pins 2 and 3 on JP1
- Wait about 5 seconds
- Close pins 1 and 2 on JP1
- Reconnect the power supply and power on the system
2.5 – Promise Controller (JP4)
1 1,2: Disabled
2,3: Enabled
2
3
2.6 – Onboard ATI RAGE XL (JP1)
1 1,2: Enabled
2,3: Disabled
2
3
10
http://www.tyan.com