TABLE OF CONTENTS WINE CHILLER SAFETY IMPORTANT SAFE-GUIDES REFRIGERANT GAS WARNINGS PARTS BREAKDOWN BUILT-UNDER SERIES IMPORTANT SAFETY INSTRUCTIONS INSTALLATION INSTRUCTIONS Before using your wine chiller Installation of your wine chiller Electrical connection Extension cord Power bar with surge protector Installing stainless steel handle OPERATING YOUR WINE chiller Recommended temperature settings Storage...
WINE CHILLER SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the Safety Alert Symbol. This symbol alerts you to potential hazards that can kill or injure you and others.
IMPORTANT SAFEGUIDES Before the appliance is used, it must be properly positioned and installed as described in this manual, so read the manual carefully. To reduce the risk of fire, electrical shock or injury when using the appliance, follow basic precaution, including the following: •...
• Use two or more people to move and install appliance. Failure to do so can result in back or other injury. • To ensure proper ventilation for your appliance, the front of the unit must be completely unobstructed. Choose a well-ventilated area with temperatures above 16°C (60°F) and below 32°C (90°F). This unit must be installed in an area protected from the element, such as wind, rain, water spray or drips.
PARTS BREAKDOWN Control Panel Leveling Legs Wooden Shelves Top Hinge Kick plate Glass Door with Handle BUILT-UNDER SERIES (Built under a kitchen table top) 30cm Wine Cooler...
60cm Wine Cooler IMPORTANT SAFETY INSTRUCTIONS To reduce the risk of fire, electrical shock, or injury when WARNING using your appliance, follow these basic precautions: • Read all instructions before using the wine chiller. • DANGER or WARNING: Risk of child entrapment. Child entrapment and suffocation are not problems of the past.
INSTALLATION INSTRUCTIONS Before using your wine chiller − Remove the exterior and interior packing. − Check to be sure you have all of the following parts: shelves 2 Keys Aluminium Handle Instruction Manual − Before connecting the Wine Chiller to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
3-prong wall outlet. The cord should be secured behind the appliance and not left exposed or dangling to prevent accidental injury. The appliance should always be plugged into its own individual electrical outlet which has a voltage rating that matches the rating label on the appliance. This provides the best performance and also prevent overloading house wiring circuits that could cause a fire hazard from overheated.
Illustration # 1 Illustration # 2 Gasket Phillips Head Screw Driver Phillips Head Screw Handle OPERATING YOUR WINE CHILLER It is recommended you install the wine chiller in a place where the ambient temperature is between 19ºC-24ºC (66ºF-75ºF), and humidity is under 60%. If the ambient temperature is above or below recommended temperatures, the performance of the unit may be affected.
Turns the interior light on or off Adjusts the temperature in 1 degree increments5-22℃(41℉-72℉) Press for 3 seconds, Toggles the temperature display between Celsius and Fahrenheit Press to turn on/off the appliance 60cm Wine Cooler Press once to turn the interior light ON or OFF. Press to increase or press to decrease the temperature in 1 degree...
Cleaning your wine chiller Turn off the power, unplug the appliance, and remove all items including shelves. Wash the inside surfaces with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to 1 cup of water.
Energy saving tips The wine chiller should be located in the coolest area of the room, away from heat producing appliances, and out of the direct sunlight. Recycling and disposal Waste electrical products (WEEE) should not be disposed of with household waste.Please recycle where facilities exist.
TROUBLESHOOTING GUIDE You can solve many common wine chiller problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. PROBLEM POSSIBLE CAUSE SOLUTION Not plugged in.
Page 15
Check to assure that the chiller is level. The chiller is not leveled Make sure the bottles don’t touch each Vibrations. The bottles are vibrating. others. There is an object under the chiller. Remove the object. Level the chiller. The rattling noise may come from the flow of the refrigerant, which is normal.
TECHNICAL DATA Category Data Model Number 30cm Models 60cm Models Category Energy efficiency class Annual Energy Consumption, AEc * 94kWh/annum 116kWh/annum Volume (litres) 138L 5-22℃ 5-18℃ Operating temperature Climate Class ** SN/N SN/N Rated Noise 40 dB(A) 41 dB Airborne acoustical noise emission class Material Case...
Need help?
Do you have a question about the ART29641 and is the answer not in the manual?
Questions and answers