Table of Contents
Advertisement
SAFETY INFORMATION
Continued
Keep the appliance area clear and free from combus-
tible materials, gasoline, and other flammable vapors
and liquids.
1.
This appliance is only for use with the type of gas indicated on
the rating plate. This appliance is not convertible for use with
other gases.
2.
Do not place propane/LP supply tank(s) inside any structure.
Locate propane/LP supply tank(s) outdoors.
3.
To prevent performance problems, the use of a propane/LP
tank of less than 100 lbs. capacity is not recommended.
4.
If you smell gas
• shut off gas supply
• do not try to light any appliance
• do not touch any electrical switch; do not use any phone in
your building
• immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions
• if you cannot reach your gas supplier, call the fire department
5.
This heater shall not be installed in a bedroom or bathroom
unless installed as a vented appliance (see Installing Damper
Clamp Accessory for Vented Operation, page 10).
6.
Before installing in a solid fuel burning fireplace, the chimney
flue and firebox must be cleaned of soot, creosote, ashes and
loose paint by a qualified chimney cleaner. Creosote will ig-
nite if highly heated. Inspect chimney flue for damage. If dam-
aged, operate heater with flue damper closed.
7.
If fireplace has glass doors, never operate this heater with glass
doors closed. If you operate heater with doors closed, heat
buildup inside fireplace will cause glass to burst. Also if fire-
place opening has vents at the bottom, you must open the vents
before operating heater.
8.
This log heater is designed to be smokeless. If logs ever appear
to smoke, turn off heater and call a qualified service person.
Note: During initial operation, slight smoking could occur due
to log curing and heater burning manufacturing residues.
9. To prevent the creation of soot, follow the instructions in Clean-
ing and Maintenance, page 17.
10. Before using furniture polish, wax, carpet cleaner, or similar
products, turn heater off. If heated, the vapors from these prod-
ucts may create a white powder residue within burner box or
on adjacent walls or furniture.
11. This heater needs fresh, outside air ventilation to run properly.
This heater has an oxygen depletion sensing (ODS) pilot light
safety system. The ODS shuts down the heater if not enough
fresh air is available. See Air for Combustion and Ventilation,
pages 4 through 6. If heater keeps shutting off, see Trouble-
shooting, pages 18 through 20.
For more information, visit www.desatech.com
For more information, visit www.desatech.com
110398-01A
SAFETY INFORMATION
PRODUCT IDENTIFICATION
12. Do not run heater
• where flammable liquids or vapors are used or stored
• under dusty conditions
13. Do not use this heater to cook food or burn paper or other
objects.
14. Do not use heater if any part has been exposed to or under
water. Immediately call a qualified service technician to in-
spect the room heater and to replace any part of the control
system and any gas control which has been under water.
15. Do not operate heater if any log is broken. Do not operate
heater if a log is chipped (dime-sized or larger).
16. Turn heater off and let cool before servicing, installing, or re-
pairing. Make sure the selector switch is in the OFF position.
Only a qualified service person should install, service, or re-
pair heater.
17. Make sure the selector switch is in the OFF position when you
are away from home for long periods of time.
18. This heater must not be connected to any external electrical source.
19. Operating heater above elevations of 4,500 feet could cause
pilot outage.
20. Provide adequate clearances around air openings.
PRODUCT IDENTIFICATION
Piezo
Ignitor
Optional
Selector
Switch
Flame
Adjustment
Optional
Remote
Knob
Control
Figure 1 - Product Identification
3 3
Log Set
Base Assembly
Control
Knob
Advertisement
Table of Contents
